User manual PIONEER PDK-1011

[. . . ] Do not install it outdoors, at a hot spring, or near a beach. Do not install the stand where it may be subjected to vibration or shock. There have been cases where unforeseen accidents such as the equipment breaking or falling over occurred after the installation of the display because the stand was not installed as instructed. [. . . ] The weight of a 50 inch plasma display is about 40 kg (88 lbs), that of a 43 inch model is about 30 kg (66 lbs), they have no depth, and are unstable. Therefore, at Caution least two people must assemble and install them. Insert the screws in the holes vertically and do not tighten them with more force than necessary. Fit the stand's support columns into the slots in the center of the bottom of the plasma display then slowly insert them directly into the slots. Be extremely careful not to insert the support columns of the stand into any part of the plasma display other than the stand insertion slots. Note that doing so might damage the plasma display panel or its ports or result in the warping of the stand. Line up the column supports with the bottom of the plasma display as indicated in the accompanying diagram. Be sure to observe the following precautions when moving or installing this product with a plasma display into a rack or other enclosure. Make sure that you always secure a space at least as large as that shown in the following diagram in front of and behind the table top stand. When moving the product more than a few meters, first remove the speaker, then remove the plasma Caution display from the stand and move the speaker, plasma display, and stand separately. When installing in a rack or other enclosure, hold the plasma display by the handles located on the rear Caution and bottom of the plasma display. If you hold the speakers, they may be damaged or twisted. But when using a rack for which the aforementioned spaces cannot be secured, place the rack as close to a wall as possible and give priority to securing the space in front. Hold the plasma display by its handles and from the bottom. [. . . ] The above specifications and exterior may be modified without prior notice to improve the product. When installing speakers set back from the display S'assurer que l'emplacement d'installation est bien plane et à niveau et prendre toutes les précautions utiles et indispensables lors de l'installation du support afin de veiller à ce que le poids soit bien uniformément réparti. Toujours assembler le support sur une table bien plane, etc. [. . . ]