User manual PIONEER PDK-4002

[. . . ] Do not use this stand for a Plasma Display other than those designated and do not modify it or use it for other purposes. Improper installation is extremely dangerous because it may result in it falling over or other accident. installation Location · Select a location that is strong enough to support the weight of the stand and the displays. [. . . ] Do not install it outdoors, at a hot spring, or near a beach. Do not install the stand where it may be subjected to vibration or shock. There have been cases where unforeseen accidents such as the equipment breaking or falling over occurred after the installation of the display because the stand was not installed as instructed. The display must always be installed by two or more people to assure it is installed safely. Before installation, turn off the power for the display and peripheral devices then remove the power cord plug from the power outlet. Prevent accidents caused by the product falling over by taking reliable measures to prevent it from falling over (see Page 10). ¶ Consult your dealer if you encounter any difficulties with this installation. ¶ Pioneer is not liable for any damage resulting from improper installation, improper use, modification, or natural disasters. Record the model number and serial number of this equipment below. Move the stand so that the stand screw holes and the nuts that connect the main display line up correctly. Note When laying down the Plasma Display, be careful so as to not scratch or damage it. After installing the stand, be sure to take special care to ensure that the equipment will not fall over. Stabilize the equipment as shown in the diagram using screws that are available on the market. Using a wall for stabilization Using strong cords to firmly stabilize it appropriately and firmly to a wall, pillar, or other sturdy element. Perform this work in the same way on the left and right sides. Note To stabilize the equipment on the floor, use screws that have a nominal diameter of 6 mm (1/4 inch) and that are at least 20 mm (13/16 inch) long. A table or an area of the floor with adequate strength should always be used to support the Plasma Display. When installing the Plasma Display, please take the necessary safety measures to prevent it from falling or overturning in case of emergencies, such as earthquakes, or of accidents. [. . . ] If you do not take these precautions, the Plasma Display could fall down and cause injury. The screws, hooks, chains and other fittings that you use to secure the Plasma Display to prevent it from overturning will vary according to the composition and thickness of the surface to which it will be attached. Select the appropriate screws, hooks, chains and other fittings after first inspecting the surface carefully to determine its thickness and composition and after consulting a professional installer if necessary. [. . . ]