User manual PIONEER PDK-5006E

[. . . ] Depending on the type of surface on which the stand is placed, the legs may leave marks on the surface, and this should be taken into consideration when selecting the place in which the stand is to be placed. Do not install it outdoors, at a hot spring, or near a beach. Do not install the stand where it may be subjected to vibration or shock. There have been cases where unforeseen accidents such as the equipment breaking or falling over occurred after the installation of the display because the stand was not installed as instructed. [. . . ] Before installation, turn off the power for the display and peripheral devices then remove the power cord plug from the power outlet. This symbol refers to a hazard or unsafe practice which can result in personal injury or property damage. Never lean on the Plasma Display or apply heavy pressure to the stand. Prevent accidents caused by the product falling over by taking reliable measures to prevent it from falling over (see page 7). Do not move the stand with the Plasma Display etc. Be sure to check that all the parts and equipment listed below have been included before beginning to assemble your stand. Table of support column position and parts for each Plasma Display When installing the 50 inch display model (with under speaker) Attach the support column stoppers to the high position notches on the back of the stand and fix them in place with screws (M5 x 10 mm [13/32 inch]). Perform this attachment using either procedure A, B or C. note Be sure to carefully store the unused support column stopper, the screws, the bolts, the hexagonal wrench, and the Operating Instructions together. When installing the 50 inch display model (without under speaker) When installing the 42 inch display model Insert the support columns into the stand and fix them in place with screws (M5 x 10 mm [13/32 inch]). (8 locations) Install each support column so that the side with the symbol ' is forward and the end with the plastic end cap (pointed) is upwards. Hole for front position use Hole for back position use After installing the stand, be sure to take special care to ensure that the Plasma Display will not fall over. Because of the Plasma Display's weight, if it could fall down, this can result in injury. For safety, be sure to take special care to ensure that the Plasma Display will not fall over. An area of the floor with adequate strength should always be used to support the Plasma Display. When installing the Plasma Display, please take the necessary safety measures to prevent it from falling or overturning in case of emergencies, such as earthquakes, or of accidents. If you do not take these precautions, the Plasma Display could fall down and cause injury. The screws, hooks and other fittings that you use to secure the Plasma Display to prevent it from overturning will vary according to the composition and thickness of the surface to which it will be attached. Select the appropriate screws, hooks and other fittings after first inspecting the surface carefully to determine its thickness and composition and after consulting a professional installer if necessary. Using strong cords to stabilize it appropriately and firmly to a wall, pillar, or other sturdy element. Perform this work in the same way on the left and right sides. The length of the cords used must be long enough to allow the stand to rotate freely. [. . . ] The length of the cords used must be long enough to allow the stand to rotate freely. Use falling prevention bolts, ropes and fittings that are available on the market. (D)) [When using high position support column and deep position shelf panel] 19. The above specifications and exterior may be modified without prior notice to improve the product. [. . . ]