User manual PIONEER PDK-50HW2A

[. . . ] Handling the cord on this product or cords associated with accessories sold with the product will expose you to lead, a chemical known to the State of California and other governmental entities to cause cancer and birth defects or other reproductive harm. Wash hands after handling This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. After installation, be sure to deliver this manual to the customer and explain to the customer how to handle the product. [. . . ] The emblem is affixed with two-sided tape (aligned with two guide pins). remove the emblem so that no tape remains. The unit will not operate properly if the emblem is not removed. Place the unit over the front of the plasma display. Hold the pen stand upright and against the bottom of the unit when inserting the Allen bolt. Be sure to turn off the power switch and disconnect the power cord from its outlet whenever making or modifying connections. Using the accessory power cord, connect the AC adapter to an ordinary power outlet. Use the provided Allen bolt to connect the free end of the unit's ground wire to the M8 hole in the rear panel of the plasma display. AC Adapter * The provided self-adhering fastener tape provides a convenient means of holding the AC adapter in place. This fastener tape can also be used when an extension cord or multiple outlet power connector is used. The accessory RS-232C cable is provided with a ferrite core near one end. Always use the dedicated AC adapter and power cord provided. Do not use any voltage or power source other than that designated, since fire or shock may result. This unit is provided with a three-wire (grounded) cord to help assure proper performance. Connect the power cord to a power outlet equipped with a ground line, to confirm that the cord is properly grounded. When using a conversion plug, connect the plug's two blades to a grounded outlet, with the plug's ground wire connected to a proper ground screw. 7 In order to produce best performance, the video card used must support 1280 x 768 resolution real display. If any other display resolution is used, it will be necessary to modify settings after installing the driver software. NOTE: The actual appearance of your task tray may differ depending on your computer configuration. This setting should be made only by a factory trained technicion or your dealer. If this function is set to ON, the plasma display's display position will change, causing a deviation between the pen tip and its onscreen display position, and which cannot be rectified by later calibration. NOTE: Input to the unit can be performed with a finger or other object in addition to the special dedicated pen; mechanical pencils or other sharp objects should not be used, however, since the screen may be scratched as a result. [. . . ] Also, malfunction may occur if the screen is touched during input by another hand or object besides the pen tip or fingertip (clothes or necktie, etc. For this reason, do not touch the screen with objects other than the actual tip of the input instrument (fingertip or pen tip). The pen may malfunction or input may be disrupted if the pen is held at an excessively sharp angle to the screen. In order to promote long life and optimum performance, regular cleaning is recommended. [. . . ]