User manual PIONEER PDK-FS04

[. . . ] When selecting the location in which the stand is to be placed, be sure to select a location with a surface sufficiently strong to bear the weight of the stand and plasma display (Product weight is listed on p. Make sure to place it in a level and stable location. Depending on the type of surface on which the stand is placed, the casters may leave marks on the surface, and this should be taken into consideration when selecting the place in which the stand is to be placed. Do not install it outdoors, at a hot spring, or near a beach. [. . . ] Side with the rubber guard is the upper side. Glass stays may be inserted into the upper, middle, or lower holes to adjust the height of the glass panel (The middle holes are designed to be used for standard installation). Be sure to work with at least one other person when attaching the display. Be careful not to allow your fingers get caught between the display and support legs. If the PDP bracket has been placed into the upper bracket holes and speakers are to be installed below the plasma display, care must be taken to ensure that the display is firmly supported as its position will be higher. Use the long hexagonal bolts to fix the plasma display to the support legs (4 locations). note The glass panel should be installed with the warning label facing upwards. If speakers are to be installed at the sides of the plasma display, they should be attached at this phase. See the installation instructions provided with your speakers for instructions on how to install them. Fix it with the screws (M4 x 10 mm: black) (2 locations: left and right). 2 Fit the legs of the MR holder into the slit of the PDP bracket, slide down at an angle, and fix into place with screws (M4 x 10mm). Be sure to use the screws to fix the glass panel into place. Note that failing to do so could cause the glass panel to fall off if you come into contact with Caution it and result in the panel breaking. Fit into slit and slide down at an angle. What to do when attaching an upright media receiver. 1 Fit the MR holder over the sides of the media receiver and fix into place using the four screws (M4 x 12 mm) provided for use in attaching the receiver to the receiver stand. Place the equipment to be connected to the display onto the glass panel and then connect the equipment to the display. Note that the glass panel and base are designed to be able to withstand loads of up to only 20 kilograms (44. 1 lbs), and that the weight of the equipment placed onto the glass panel should never exceed this limit. The legs of the MR holder are on the side of the holder with the indentations. Be sure to attach the holder in the correct direction. Do not attach the MR holder to anything other than a media receiver. [. . . ] (Le support de base qui figure ci-dessous est un support pour un écran plasma de 43 pouces avec des pieds-supports courts) Faites glisser la colonne de support centrale dans les rails du support de base et fixez-la au moyen de vis à six pans (4 emplacements). Retirez les pieds-supports courts fixés au support PDP et remplacez-les par les pieds-supports longs (Pour ce faire, veuillez utiliser la clé hexagonale jointe avec le support de base). Utiliser les vis courtes à six pans pour fixer le support PDP à la colonne de support centrale (les boulons doivent être vissés à quatre endroits). Le support peut être vissé dans les orifices supérieurs, centraux et inférieurs de la colonne de support centrale afin de régler la hauteur de l'écran d'affichage plasma. [. . . ]