User manual PIONEER PDK-TS01-L

[. . . ] Before installation, turn off the power for the display and peripheral devices then remove the power cord plug from the power outlet. This product rotates 10° to the left and right and inclines approximately 2° forward and backward. Do not place objects within the range of rotation of this product and the plasma display. Install this product so that during routine use or when it is rotated, it does not protrude from the rack or other location it has been installed. [. . . ] Check to make sure that you have all the enclosed parts before assembly and installation. Insert the screws in the holes vertically and do not tighten them with more force than necessary. Secure the support column to the stand with the Installation screws 1 (4 locations on the left and right). Using the enclosed hexagonal wrench, first loosely attach the top attachment screw, then loosely attach the bottom attachment screw. Note Be sure to carefully store the unused support columns, the hexagonal wrench, the C wrench, and the Operating Instructions together. The weight of a 50 inch plasma display (without speakers) is about 32 kg (70. 5 lbs), that of a 43 inch Caution model (without speakers) is about 26 kg (57. 3 lbs), they have no depth, and are unstable. Therefore, at least two people must assemble and install them. note Be sure to install it on a flat stable location. Insert the screws in the holes vertically and do not tighten them with more force than necessary. When rotating, take care not to allow the display to bump into walls or surrounding objects. Hold the plasma display by its handles and from the bottom. Note Be very careful not to apply force to the bases of the cables. After installing the stand, be sure to take special care to ensure that the Plasma Display will not fall over. Stabilize the equipment as shown in the diagram using screws that are available on the market. Using a wall for stabilization Using strong cords or chains to stabilize it appropriately and firmly to a wall, pillar, or other sturdy element. Perform this work in the same way on the left and right sides. The length of the cords or chains used must be long enough to allow the stand to rotate freely. To stabilize the Plasma Display on a table or on the floor, use screws that have a nominal diameter of 6 mm (1/4 inch) and that are at least 20 mm (13/16 inch) long. Note Use falling prevention bolts, ropes, chains, and fittings that are available on the market. A table or an area of the floor with adequate strength should always be used to support the Plasma Display. [. . . ] Use a screw that has a nominal diameter of 4 mm (3/16 inch) and length from 20 to 30 mm (13/16 to 1-3/16 inch) to fix the rotation to the front. To remove the plasma display from the stand, be sure to always follow the procedure described below to Caution prevent accidents. The support columns might slip out of place and fall over. First clear a space on a flat floor etc. [. . . ]