User manual PIONEER PDK-TS06

[. . . ] Please have a good understanding of these matters before reading the main text of the manual. Ignoring this indication and improper handling could be the cause of personal injury such as a serious injury or death. Ignoring this indication and improper handling could cause injury to a person or damage to the surrounding household belongings. This symbol informs that there are contents that demand caution (including warnings). [. . . ] - Do not set on shaky stands, tilted surfaces or other unstable places. Doing so could cause the Plasma Display to tip over or fall, resulting in injury. Moreover, Do not install into a vehicle. If the ventilation holes are covered, the heat will build up inside, and this could lead to fire. For example, do not install the Plasma Display in narrow spaces where ventilation is poor, do not place covers over it, etc. - Do not install the Plasma Display near air conditioner air outlets or in places where vibrations are strong. Doing so could lead to fire or electric shock. - Do not install the Plasma Display in humid or dusty places or places exposed to soot or vapor (such as in kitchens, near humidifiers, etc. do not install the Plasma Display outdoors. Doing so could lead to fire or electric shock. - When installing the Plasma Display, leave sufficient space around it, as shown in the diagram. Failure to do so could cause heat to build up inside, leading to fire. - When installing the Plasma Display on a stand with casters, be sure to block the casters. If the stand should move, the Plasma Display could fall, resulting in injury. - The Plasma Display is heavy, so be sure to install in a stable place and take measures to prevent it from tipping over and causing injury. the Plasma Display has a high center of gravity. It should be unpacked and moved by a minimum of three people, holding it at the top and bottom. The Plasma Display's screen could get dirty, resulting in poor picture quality. [. . . ] Remove the two boxes containing the feet and The foot starting from the perforated line in the center to reveal the mounting surface. In step 2, insert the bar on the guide pins, and tighten with the included stand assembly screws. If not, the monitor could tip over, resulting in injury. On the bar side, after pulling out the slit Fold down the front and rear of the box Check that the stand and plasma display are facing the proper direction, then insert the plasma display into the stand. [. . . ]