User manual PIONEER PDK-TS07

[. . . ] this product is Pioneer 42 inches Plasma Display (PDP425CMX / PDP-42MXE10 / PDP-42MXE10-S) , 43 inches Plasma Display (PDP-433CMX / PDP-433MXE / PDP-434CMX / PDP43MXE1 / PDP-43MXE1-S) , 50 inches Plasma Display (PDP503CMX / PDP-503MXE series / PDP-504CMX / PDP-50MXE series / PDP-505CMX / PDP-507CMX). For detailed information on how to attach these speakers to any other monitor, contact the retailer where you purchased the product for assistance. Do not install or modify the product other than specified. [. . . ] Record the model number and serial number of this equipment below. PDK-TS07/PDK-TS01 Keep these numbers for future use. This symbol refers to a hazard or unsafe practice which can result in personal injury or property damage. Check to make sure that you have all the standard accessories before assembly and installation. Turn the base cover over so the underside is facing up. Note Assemble the stand with a soft sheet placed under the base cover. If a sheet is not laid before assembly, the front surface of the base cover may be scratched. The Plasma Display is heavy, has no depth, and is unstable, so be sure to have at least two people assemble and install it. Regarding the stand pipe bolt holes when the stand is used as a desktop stand Plasma Display model Bolt holes used with stand orientation 50 inch display model B, B' 43 inch display model A, A' 42 inch display model A, A' Note Place a sheet or protective cover to protect the display from scratches or damage. Assemble only with the Plasma Display lying flat on a table or similar surface. With the Plasma Display lying flat, insert and secure the two Installation bolts 1 (M8 x 20 mm) in the holes "a" located in center of the Plasma Display housing. At this point, tighten these bolts 1 only until the threads are no longer visible when viewed from the side (you will be unable to attach the display if the bolts are screwed in completely). Installation bolt 1 Plasma Display housing Stop screwing down the bolt when the threads are no longer visible. As shown in table, hook the stand pipe holes (either A or B) onto the bolt heads of the installation bolts 1, then slide the stand upwards to the Plasma Display until it engages the installation bolts 1. It slides no more than 19 mm because of the structure of the stand. Pass the installation bolts 2 (M8 x 40 mm) through the stand pipe holes (either A' or B'), and then screw them into the main Plasma Display with the accessory hexagonal wrench. the combinations of holes used are A ­ A' and B ­ B'. Move the stand so that the stand screw holes and the nuts that connect the main display line up correctly. [. . . ] * 50 inch display model (PDP-507CMX/PDP-50MXE20/PDP-50MXE20-S) ** 42 inch display model (PDP-425CMX/PDP-42MXE10/PDP-42MXE10-S) The above specifications and exterior may be modified without prior notice to improve the product. Insérez les colonnes de support dans le support de couverture de table. Comme indiqué sur le schéma ci-dessus, placez les trous de la colonne de support (A ou B) sur les têtes des boulons d'installation 1, puis faites glisser le support vers le haut dans l'écran à plasma principal jusqu'à engagement des boulons d'installation 1. [. . . ]