User manual PIONEER PDK-TS18

[. . . ] Always have an installation specialist or your dealer install and set up the product. PIONEER cannot assume liabilities for damage caused by mistake in installation or mounting, misuse, modification or a natural disaster. To ensure the user's safety, be sure to select a place sufficiently strong to bear the weight of the Plasma Display and the different units. Installation should be performed by a minimum of three persons. [. . . ] - Be sure to have the Plasma Display installed by your store of purchase following the instructions in this manual. Doing so could cause the Plasma Display to tip over, resulting in injury. Doing so could cause the Plasma Display to tip over, resulting in injury. if a part should be damaged , contact the store of purchase. - Each unit is designed specifically for use with Pioneer 61-inch (PDP-6100HD) plasma displays. Please do not mount any other equipment with these items. Doing so may cause the item to fall over and result in injury. - Do not set on shaky stands, tilted surfaces or other unstable places. Doing so could cause the Plasma Display to tip over or fall, resulting in injury. If the ventilation holes are covered, the heat will build up inside, and this could lead to fire. For example, do not install the Plasma Display in narrow spaces where ventilation is poor, do not place covers over it, etc. - Do not install the Plasma Display near air conditioner air outlets or in places where vibrations are strong. Doing so could lead to fire or electric shock. - Do not install the Plasma Display in humid or dusty places or places exposed to soot or vapor (such as in kitchens, near humidifiers, etc. do not install the Plasma Display outdoors. Doing so could lead to fire or electric shock. - When installing the Plasma Display, leave sufficient space around it, as shown in the diagram. Failure to do so could cause heat to build up inside, leading to fire. - When installing the Plasma Display on a stand with casters, be sure to block the casters. If the stand should move, the Plasma Display could fall, resulting in injury. [. . . ] Hold the bottom and the grips on the back of the plasma display and support the top when inserting the plasma display into the stand. Hold both sides of the plasma display and lift it up, then place the plasma display onto the stand so that the holes located at the bottom of the display engage with the stand. Pull the top of the plasma display forward and while doing so, insert the four supplied display mounting screws into the holes in the stand and tighten them. - As a fall prevention measure against earthquakes and shocks, fasten the two safety fittings into the screw holes used for anchoring at the rear cover of the plasma display. [. . . ]