User manual PIONEER PDK-TS33A

[. . . ] installation · Consult your dealer if you encounter any difficulties with this installation. Pioneer is not liable for any damage resulting from improper installation, improper use, modification, or natural disasters. Use with other model is capable of resulting in instability causing possible injury. For further information, please contact the store where you purchased your display. [. . . ] Insert stand pipe (R) into the side marked "R" and stand pipe (L) into the side marked "L". Insert the stand pipes, making sure to match them to the raised portion of the base cover. After assembling the stand, attach the falling prevention metal fittings with the installation screws (M4 × 35 mm: black). Be sure not to attach the falling prevention metal fittings in the reverse position. Assemble the stand with a soft sheet placed under the base cover. If a sheet is not laid before assembly, the front surface of the base cover may be scratched. Please take care when installing stand pipes (L) and (R) to ensure that they are in the correct positions. This part prevents reflection of the cables connected to the back of the Pioneer display and television on the base cover. Attach it after anchoring the base cover on a flat stable place. Peel off one side of the double-stick tape on the cushion and attach the cushion onto the base cover. Be careful that the cushion does not catch on the pipe insertion holes. If there is a gap, the cushion may peel off. After attaching the Pioneer television onto the stand, peel off one side of double-stick tape and attach the light-blocking pad onto the position in the bottom diagram (PDP-LX5090 / PDP-LX5090H / PDP-C509A only). The weight of a Pioneer display and television is about 30 kg (66 lbs), they have no depth, and are unstable. Therefore, at least two people must assemble and install them. Secure the parts marked with the arrows (holes marked "T") using a Phillips screwdriver. After manually turning the screw lightly two or three times, tighten it with a screw-driver. Lay the Pioneer display and television down flat. [. . . ] To stabilize the equipment on a table, use screws that have a nominal diameter of 4 mm (5/32 inch) and that are at least 20 mm (13/16 inch) long. Use hooks, cords, and fittings that are available on the market. The above specifications and exterior may be modified without prior notice to improve the product. Using a wall for stabilization When the side speakers are installed Insérez la colonne de support (R) dans le côté marqué « R » et la colonne de support (L) dans le côté marqué « L ». [. . . ]