Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual PIONEER PDK-WM01. We hope that this PIONEER PDK-WM01 user guide will be useful to you.
Lastmanuals help download the user guide PIONEER PDK-WM01.
Detailed instructions for use are in the User's Guide.
[. . . ] â· Do not install the stand where it may be subjected to vibration or shock. â· There are cases where it cannot be installed because of the structural strength of the wall, so consult with an expert installer. â· Thoroughly read and always follow the plasma display operating instructions for more information about the installation location. Prior to installing this product, please read Pioneer's technical manual thoroughly and heed its content. [. . . ] Removing the push rivet of the lock plate and the bottom anchor screw (M6 x 14mm) (2 locations: left and right sides). 1 Move the push rivet of the lock plate to its unlocked position so the lock plate is in the condition shown in the figure. Screws used to fix the wall-hanging metal fitting firmly to the wall surface are not included. Pull the push rivet Be careful not to lose the 2 anchor screws (M6 x 14mm) because they will be used later. Releasing the lock bar (2 locations: left and right sides). 1 Lift the lock bar to the position where the lock on the Fix it firmly in place symmetrically to the left and right (4 or more locations). The screws and bolts used for this step vary according to the strength and the materials of the wall, so prepare these separately. 2 While holding the lock bar up, pull out the bottom of Perform this installation work after confirming the strength of the wall, columns, etc. Hanging the hook of the PDP side metal fitting on the wall side metal fitting Fix the PDP side metal fitting firmly to the plasma display with bolts M8 (6 locations). Sure that the lock bar is fully lowered. Spread a sheet or similar material so that the display will not be scratched or damaged. Lift the lock bar to its unlocked position. If you plan to install speakers, install them at this stage. Always have at least 2 people do this task. If speakers are attached, do not hold the speakers to perform this attachment. Be extremely careful if there is a speaker attached to the bottom, because if there is, wiring etc. Is easily caught between the wall and the speaker. If the plasma display is slightly tilted from the vertical after it is installed on the wall, you can adjust this tilt by attaching the tilt adjustment metal fitting. [. . . ] Raising the lock bar and pulling the bottom of the plasma display forward. Removing the plasma display without removing the tilt adjustment metal fitting may scratch the wall. Pull out the bottom of the plasma display. Raise the lock bar (either the left or the right side). [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE PIONEER PDK-WM01
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual PIONEER PDK-WM01 will begin.
