User manual PIONEER PDK-WM02

[. . . ] â· Do not install where vibration or shock may occur. â· There are cases where it cannot be installed because of the structural strength of the wall, so consult with an expert installer. â· Thoroughly read and always follow the plasma display operating instructions for more information about the installation location. Prior to installing this product, please read Pioneer's technical manual thoroughly and heed its content. [. . . ] Removing the screws from the top and bottom of the Hung on wall unit (4 locations: top and bottom, left and right side). Screws used to fix the wall-hanging metal fitting firmly to the wall surface are not included. Bolts M8 x 6 Hexagon wrench x 1 (Opposite side 6 mm for M8 use) Be careful not to lose the 2 anchor screws (M5 x 10mm) because they will be used later. Removing the PDP side metal fitting from the wall side metal fitting. Attach the PDP side metal fitting to the plasma display with bolts M8 carefully so the top and bottom are not accidentally reversed (6 locations). 1 First decide the position to install the plasma display as you check the strength of the wall and beam, then set the location at the center of the screen. Spread a sheet or similar material so that the display will not be scratched or damaged. 2 Temporarily attach the screw used for positioning about 230mm above the center of the screen. After the metal fitting is fixed by the temporarily attached screw, remove it if it is not necessary. If you plan to install speakers, install them at this stage. 3 Hang the wall side metal fitting on the screw referred to in step 2. Fix it firmly in place symmetrically to the left and right (4 or more locations). The screws and bolts used for this step vary according to the strength and the materials of the wall, so prepare these separately. Hanging the wall side metal fitting on the screw. Perform this installation work after confirming the strength of the wall, columns, etc. 4 Measure the distance from the ceiling to the wall side metal fitting (A1, A2) and the distance from the floor to the metal fitting (B1, B2), then after adjusting it so it is horizontal, fasten it to the wall with bolts. A1 = A2 or B1 = B2 Attachment holes (attached symmetrically on the left and right: 4 or more locations) Hanging the cant hooks of the PDP side fitting on the wall side fitting (4 locations). Make sure that the cant hooks are firmly hung and that the plasma display is attached horizontally in its correct position. [. . . ] Before beginning this procedure, remove the power plugs of the plasma display and peripheral devices from their outlets. Always have at least two people do this task. After slightly raising the plasma display once (1), raise it upwards to the left (2) 1 till you cannot raise it any higher. You can remove it by pulling it towards yourself in 3 this position (3). [. . . ]