User manual PIONEER PDK-WM03

[. . . ] When opening the package, check that the parts listed below are present in the proper quantities. This Operating Installations uses pictograms to indicate matters required for the installer to install the plasma display properly and safety in order to ensure proper, safe use of the product and prevent injury to yourself and others or damage to property. The pictograms and their meanings are indicated below. Be sure to understand them well before reading the rest of the manual. [. . . ] Do not use with any other equipment since the equipment could fall and cause injury. Doing so will prevent the dissipation of heat and may result a fire. Do not use the plasma display in the following ways: Do not install the plasma display in a tight place where ventilation is poor, place a cover on it, etc. * Do not install the plasma display in front of the vents of an air conditioner or heater, or in a place where there is strong vibration. Doing so may result in fire or electrical shock. * Do not install the plasma display in humid or dusty places, or where it will be exposed to greasy smoke or steam (such as near cooking equipment or humidifiers). do not use the plasma display outdoors. Doing so may result in a fire or electrical shock. * Leave sufficient space around the plasma display when installing it. Failure to do so may load to head buildup within the display and could result in fire. * Hold the plasma display in place while attaching it to the unit. Failing to do so may lead to it falling and causing injury. * Do not apply pressure to the glass surface of the plasma display. The pressure could cause it to crack and it could cause injury. * Do not attach screws to the plasma display without the fittings mounted. * Never use screws other than those supplied. Use of such screws could cause breakdown. Avoid rooms with a lot of dust, humidity, greasy smoke, or tobacco smoke. Avoid places in which the screen is exposed to direct sunlight or illumination light. When surrounding light hits the screen directly, the image appears washed out and is difficult to view. Avoid places which reach high temperatures or low temperatures. There are two display fittings, one for the right side, the other for the left. [. . . ] 1 Place the plasma display on a cushion or other cushioning material that has been placed on a level floor, then change the orientation as illustrated in the diagram. Be sure to use gloves while doing this work as a precaution against possible injury. When installing the plasma display in a high position to which it cannot be lifted by hand, it can be suspended from the eye bolts at the tops of the display fittings and lifted with a crane or other heavy machine. Check that the eye bolts are tight before doing this. [. . . ]