User manual PIONEER PDP-4270XA

[. . . ] The plug or adaptor or the distribution panel should be provided with 13 A fuse. As the colours of the wires in the mains lead of this appliance may not correspond with coloured markings identifying the terminals in your plug, proceed as follows ; The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol , or coloured green or green and yellow. The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. [. . . ] If you will not use the remote control unit for an extended period of time, remove the batteries from it. To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with a standard DIN45325 plug (IEC169-2), plug it into the antenna terminal at the rear of the Media Receiver. To help prevent noise, attach the supplied ferrite core to the connector end of the power cord as shown. Use the supplied cable tie to prevent the ferrite core from slipping on the cable. To power outlet UK and Eire AC power cord Disconnect the power cord from the power outlet, Plasma Display and Media Receiver when the system is not going to be used for a long period of time. Unless you set up TV channels that you can watch under the current conditions, you cannot tune in those channels. Turning on/ off the power When the Media Receiver is plugged into a power outlet, it is placed into the standby mode; the STANDBY indicator on its front panel should flash red. The Media Receiver stays in the standby mode unless it is unplugged from the power outlet. To turn off the system, press a on the remote control unit or STANDBY/ON on the Media Receiver. In this case, sound is determined by the video source. A still image appears on the right screen while a moving image is shown on the left screen. Use the following procedure to capture and freeze one frame from a moving image that you are watching. When this function is not available, a warning message appears. 3 Repeat step 2 until you access the desired submenu item. Energy Save No Signal off No Operation off For some menu items, press / instead of /. You can return to the upper menu levels by pressing RETURN. This section describes how to automatically search for and set up TV channels. This section describes how to set up TV channels manually. When the Plasma Display System is switched on for the first time after purchase, the initial auto installation is initiated. You can automatically set language, country and channels in successive operations. [. . . ] Pressing stops automatic subpage change and performs its respective button function. When receiving TOP Teletext, you can read a TOP text overview. 3 Press / and / to select the desired block or group When the TOP Over View screen is in display, no other buttons are available than i +/i ­, g, e, and a. Make sure that the Plasma Display and the Media Receiver are connected correctly. [. . . ]