User manual PIONEER PDP-42RXE

[. . . ] Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. The wires in this mains lead are coloured in accordance with the following code: Green and Yellow : Earth Blue : Neutral Brown : Live If the plug provided is unsuitable for your socket outlets, the plug must be cut off and a suitable plug fitted. The cut-off plug should be disposed of and must not be inserted into any 13 amp socket as this can result in electric shock. The plug or adaptor or the distribution panel should be provided with 5 A fuse. [. . . ] When installing the Plasma Display, please take the necessary safety measures to prevent it from falling or overturning in case of emergencies, such as earthquakes, or of accidents. If you do not take these precautions, the Plasma Display could fall down and cause injury. The screws, hooks, chains and other fittings that you use to secure the Plasma Display to prevent it from overturning will vary according to the composition and thickness of the surface to which it will be attached. Select the appropriate screws, hooks, chains and other fittings after first inspecting the surface carefully to determine its thickness and composition and after consulting a professional installer if necessary. The remote control unit cannot operate the system if the batteries in the unit are empty. When this happens, replace the batteries with new ones. When you replace the batteries, use alkaline ones. Do not mix batteries of different types. Different types of batteries have different characteristics. Mixing old and new batteries can shorten the life of new batteries or cause chemical leakage in old batteries. Do not leave dead batteries in the remote control unit; chemical leakage will occur. If you find any chemical leakage, wipe thoroughly with a cloth. The batteries supplied with this product may have a shorter life expectancy due to storage conditions. If you will not use the remote control unit for an extended period of time, remove the batteries from it. The battery polarities must correspond with the (+) and (­) indicators in the battery compartment. Allowed operation range of the remote control unit Operate the remote control unit while pointing it toward the remote control sensor located at the bottom centre of the front panel of the Plasma Display. The distance from the remote control sensor must be within 7 m and the angle relative to the sensor must be within 30 degrees in the right or left direction. Do not expose the remote control unit to shock, liquid, or high humidity. Do not place the remote control unit under direct sunlight; the unit may deform. The remote control unit may not work properly if the remote sensor window of the Plasma Display is under direct sunlight or strong lighting. When any obstacle exists between the remote control unit and the remote control sensor, the remote control unit may not function. As the batteries become empty, the remote control unit can function within a shorter distance from the remote control sensor. [. . . ] Refer to your DVD player instruction manual for the signal type. To use the HDMI terminal, activate the terminal and specify the types of video and audio signals to be received from the connected equipment. For the types of these signals, refer to the operation manual supplied with the connected equipment. When connecting with DVI jack, such as a DVD player, connect the audio cable to the AUDIO INPUT-L/R jacks on the Plasma Display and to the audio output jacks on the required equipment. [. . . ]