User manual PIONEER PDP-506FDE

[. . . ] This equipment complies with the requirements of Directives 89/336/EEC and 73/23/EEC as amended by 93/68/ EEC. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. The wires in this mains lead are coloured in accordance with the following code: Green and Yellow : Earth Blue : Neutral Brown : Live If the plug provided is unsuitable for your socket outlets, the plug must be cut off and a suitable plug fitted. The cut-off plug should be disposed of and must not be inserted into any 13 amp socket as this can result in electric shock. [. . . ] You can then turn on the system again by pressing a or 0 to 9 on the remote control unit or STANDBY/ON on the Media Receiver. If you press 0 on the remote control unit, images come from the INPUT 1 source. if you press 1 to 9 , TV images display. You can also press POWER on the Plasma Display to turn off the system. However, you cannot then turn on the system again by pressing the buttons on the remote control unit and Media Receiver. If you are not going to use the Plasma Display System for a long period of time, be sure to remove the power cord from the power outlet. When the system is placed into the standby mode, the main power flow is cut and the system is no longer fully operational. You can check the current status of the system with the indicators on the Plasma Display and Media Receiver. indicator Status Plasma Display POWER ON STANDBY Media Receiver POWER ON STANDBY The power cords of both the Plasma Display and the Media Receiver have been disconnected. For other than the above, see "Troubleshooting" on page 46. Using P +/P ­ on the remote control unit P +/P ­ cannot pick up channels that are set to skip. Using 0 ­ 9 on the remote control unit When viewing Teletext information: View a page directly which is 3-digit page number from 100 to 899 by pressing buttons 0 to 9. In the standby mode, when you press 0, the power turns on and images come from the INPUT 1 source. Or, when you press any button from 1 to 9, TV images display. Tuning to your favourite channels Changing the volume and sound If you have registered your favourite channels, selecting from the registered list may be the easiest way to tune to those channels. Using i +/i ­ on the remote control unit You can register up to 16 channels as your favourite channels. 1 While watching broadcasts, press ENTER to call up the Using e on the remote control unit Using g on the remote control unit Each time you press g, MTS toggles as shown below. In each of the sound multiplex mode selected using the g button, the display changes depending on broadcasting signals being received. Once the MONO mode is selected, the Plasma Display System sound remains mono even if the system receives a stereo broadcast. You must switch the mode back to I or II mode if you want to hear stereo sound again. Selecting a sound multiplex mode while the input source is INPUT 1 to 4 does not change the type of sound. In this case, sound is determined by the video source. [. . . ] In this case, operate the system after first turning off the power of the Plasma Display and the Media Receiver, or unplugging the power cord and re-plugging it in after 1 or 2 minutes. Are batteries inserted with polarity (+, ­) aligned?Are you using it under strong or fluorescent lighting?Check if the input source for video has been unintentionally selected although you want to watch a TV channel. [. . . ]