User manual PIONEER PDP-LX5090

[. . . ] Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. This appliance is supplied with a moulded three pin mains plug for your safety and convenience. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 13 amps and that it is approved by ASTA or BSI to BS1362. If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. [. . . ] This function lets you skip group of services, such as radio and text data services. You can select from among "Off", "Radio", "Data" or "Both". 4 Select a new location (/// then ENTER). To change a page on the Sort screen in step 4, select / on the screen with /// to select a page, and then press ENTER. You can select "DTV Setup" only when watching DTV channels. Use the following procedure to switch between the PCM and Dolby digital audio format. With this function on, the flat screen TV checks if updated software is available and then downloads it (as necessary). after this , the system executes Add New Channels operation (page 40). This series of operations are automatically executed at the specified time. You can select "DTV Setup" only when watching DTV channels. You may manually configure language settings for audio, subtitles, and teletext. The flat screen TV automatically selects the language based on the "Country" setting (page 27) when the selected language for audio, subtitle, or teletext is not available. You can select "DTV Setup" only when watching DTV channels. For Auto Update to start, there must be approximately two hours left before the start of the next preset recording/watching. 60 seconds before the scheduled update, a message prompt appears asking if you want to carry out Auto Update or not. Auto Update automatically starts if "OK" is selected or no selection is made after 50 seconds. You can select "DTV Setup" only when watching DTV channels. You can set the time your flat screen TV performs Auto Update each day. Some stations bring you programmes with the MHEG (Multimedia and Hypermedia Expert Group) application encoded, letting you experience DTV interactively. When provided, the MHEG application will start when you press any of the colour buttons or m. note · This function may not work properly when subtitle is activated (see page 40). The screen saver automatically starts when no operation is performed for three minutes while receiving DTV radio channels. [. . . ] Photo data stored in digital still cameras cannot be read through the USB interface. SCART (INPUT 1) 1 4 7 Audio right output Common earth for audio Blue input 2 5 8 Audio right input Earth for Blue Audio-video control 3 6 9 Audio left output Audio left input Earth for Green 10 Not used 13 Earth for Red 16 Red/Green/Blue control 19 Video output SCART (INPUT 2) 1 4 7 Audio right output Common earth for audio Not used Audio left output Audio left input Earth 10 AV link control 13 Earth 16 Not used 19 Video output SCART (INPUT 3) 1 4 7 Audio right output Common earth for audio Blue input Audio left output Audio left input Earth for Green HDMI (High-Definition Multimedia Interface) is a digital interface that handles both video and audio using a single cable. HDCP (High-bandwidth Digital Content Protection) is a technology used to protect copyrighted digital contents that use the Digital Visual Interface (DVI). Design and specifications are subject to change without notice. [. . . ]