User manual PIONEER PDP-S01-LR

[. . . ] When connecting this product or any other audio or visual equipment to an amplifier, be sure the power to the amplifier is turned off. Avoid raising the volume too high when using an graphic equalizer to greatly amplify high-frequency sounds. Never raise the volume too high when using a low-output amplifier. Depending on the manner of installation, there may be times when colors blur or other effects appear on screen if the speaker is placed in close proximity to any other type of monitor. [. . . ] Various symbols are used in this Operating Instructions for the safe and proper use of the product as well as preventing any injury or damage to persons or property. These symbols and their meanings are described below. Please have a good understanding of these matters before reading the main text of the manual. The speakers are designed specifically for the left (L) and right (R) sides. When mounting them on the display, refer to the letters ("L" and "R") indicated on the speakers' hooks. Remove the seals from the cushions and then attach the cushions to the sides of the speakers in the locations indicated in the diagram below. Ignoring this indication and improper handling could be the cause of personal injury such as a serious injury or death. Ignoring this indication and improper handling could cause injury to a person or damage to the surrounding household belongings. This symbol is used to mark cautions (and warnings) containing instructions which must be followed. This symbol is used to mark items containing instructions about actions which are prohibited (i. This symbol is used to mark items containing instructions or other content requiring the user to take certain actions. *Tighten the screws while pushing the speakers lightly against the Plasma Display. Check to be sure that all four screws have been screwed firmly into place. When the speakers are installed on the Plasma Display, do not move the unit by lifting up the speakers. Turn off the power of all connected units before connecting the cords. Connect the display's SPEAKER R and L terminals with the speakers' terminals using the included connection cords. There is polarity with the conductor of each connection cord. Connect each conductor to the correct terminal. While holding the button of each speaker terminal, insert a conductor of the connection cord. After connecting the speaker terminals with the connection cords, confirm that the cords are connected at the terminal securely by tugging on the cords. A loose connection may cause sound dropouts or noise. Cord Clamper Remove the seal from the rear of the cord clampers, attach the clampers in the desired position, and clamp the cords into place. [. . . ] Cord Clamper Remove the seal from the rear of the cord clampers, attach the clampers in the desired position, and clamp the cords into place. If the cabinet is seriously stained, soak a cloth in a neutral detergent solution, wring well and, afer wiping, remove moisture by wiping with a dry colth. If you want to use a chemical cloth for cleaning, read well the caution provided with the chemical cloth product. do not use solvent such as thinner or benzine for cleaning. [. . . ]