Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual PIONEER PDP-S13-LR. We hope that this PIONEER PDP-S13-LR user guide will be useful to you.
Lastmanuals help download the user guide PIONEER PDP-S13-LR.
Detailed instructions for use are in the User's Guide.
[. . . ] When an excessive input signal is sent to the speakers, the protective device is activated and loud high-pitched sounds will be prevented. In this case, lower the volume of the plasma display during use. After 5 to 10 seconds, the speakers are restored automatically. [. . . ] 1 Push rivets into each outside hole A of brackets (on the right and left sides) for installing the speakers at the bottom. 2 Fix each outside hole B of brackets (on the right and left sides), for installing the speakers at the bottom, with screws. 4 Similarly, attach two holders to the top and bottom of the other speaker. The illustration below shows how to attach of the right speaker. 1 Fix the upper screw temporarily in advance to hang the speaker on the display (In this case, leave a space of about 5 mm between the head of the screw and the display). 4 Adjust the position so that the speaker is parallel to the display and then fix the upper and lower screws firmly. 3 Insert the screws into the two outside holes of bracket (at the center), for installing the speakers at the bottom, and tighten them. 5 Attach the left speaker following the same procedure as described above. Take care to ensure that the display does not hit the speakers in steps 1 and 2 when speakers are installed on the display. 1 Place it below the display while inclining one speaker and insert it into the bracket on the right side. Do not hold the speakers and raise the display. When the speakers are installed on the right and left sides When the speakers are installed at the bottom 2 Similarly, insert the other speaker into the bracket on the left side. 3 Adjust so that the clearance between the speakers is lost and so that the speakers are not shifted to the right or left. 1 Switch off the power of the plasma display. Push the lever, insert the cable into the hole, and release the lever. 4 Fix the two points in the center of the display with screws. For the output terminals on the plasma display, push the lever, insert the cable into the hole, and release the lever. 5 Fix the two points (four points in all) on the right and left sides with screws. [. . . ] Speed clamps are included with the plasma display for tidying your cables and keeping extra cable length out of the way. Use a polishing cloth or dry cloth to wipe off dust and dirt. When the cabinet is very dirty, wipe with a soft cloth moistened with water-diluted cleanser; then wipe again with a dry cloth. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE PIONEER PDP-S13-LR
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual PIONEER PDP-S13-LR will begin.
