User manual PIONEER PDP-S41

[. . . ] Therefore, at least two people must assemble and install them. ⷠWhen installing the speaker, do not use any screws other than those supplied, otherwise the speaker may come off from the main unit and fall over. Please handle the speaker with sufficient care, as the grille net and the cabinet can become damaged or broken when they are subjected to strong external impacts. ⷠPlacing a CRT computer screen or CRT monitor near to the speaker may result in interference or color distortion. [. . . ] Protective wrapping Front side of the speaker The upper side of the speaker does not have a round corner. The bottom side of the speaker has a round corner when viewed from the front side of the Plasma Display. To avoid any damage to the speaker and/or table top stand from striking against each other, fit the speaker to the mounting fittings while confirming their locations. As you may easily strike the stand, use the protective wrapping in which the speaker was wrapped between the speaker and stand. ⷠWhen the speaker mounting fittings do not fit the grooves at the rear of the speaker, adjust the speaker mounting fittings angle. Fix the speaker mounting fittings and the speaker with the supplied screws. ⷠFix the center part of the speaker first with the supplied screws, then fix the right and left sides alike. If you want to move the Plasma Display unit, make sure that you remove the speaker first. In addition, do not move the display holding on to the mounting fittings. this can result in injury or damage to the unit. The screw hole at the bottom surface of the speaker mounting fitting is used when the Plasma Display is installed on the wall. It is not used when installed with the stand. NOTE: If after attaching the speaker its position needs to be adjusted horizontally or vertically, first loosen the speaker mounting screws, reposition and then tighten the screws again at the appropriate position. To do so, connect the cable with the gray line to the terminals and the white cable to the terminals. Black Gray line White Gray line · When you release the lever, it clamps onto the speaker cable. To do so, connect the cable with the gray line to the terminals and the white cable to the terminals. Be sure to turn the connected devices off and remove the power cord from the wall outlet beforehand when changing the connection or installation method. ⷠIf you insert the speaker cable too far so that the insulation is touching the speaker terminal, you may not get any sound. Check if the end of the speaker cables are securely connected to the terminals by slightly tugging on the cable after making connections. Loose connections may result in sound dropouts or noise. [. . . ] ⷠWhen a chemical cloth is used, read the cautions for the chemical cloth carefully. NOTE: Specifications and design subject to possible modification without notice, due to improvements. If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. [. . . ]