User manual PIONEER PDP-S44-LR

[. . . ] Always have an installation specialist or your dealer install and set up the product. PIONEER cannot assume liabilities for damage caused by mistake in installation or mounting, misuse, modification or a natural disaster. In order to prevent damage to the speaker system resulting from input overload, please observe the following precautions: Do not supply power to the speaker system in excess When connecting or disconnecting pin-plugs, be sure that amplifire power is OFF. When using a graphic equalizer to emphasize loud sounds of a high frequency range, do not use excessive amplifier volume. [. . . ] When the speakers are installed on the display, do not move the unit by lifting up the speakers. Do not set on shaky stands, tilted surfaces or other unstable places. Doing so could cause the Plasma Display to tip over or fall, resulting in injury. Moreover, Do not install a Plasma Display into a vehicle. Do not install the Plasma Display in humid or dusty places or places exposed to soot or vapor (such as in kitchens, near humidifiers, etc. Do not let any water get into or onto the speaker. Doing so could result in fire or electric shock. also , do not use the speakers outdoors. Doing so could result in fire or electric shock. Do not place heavy objects on the connection cords or let the cords run under the display. the cords could be damaged , leading to fire or electric shock. Do not insert or drop metal objects, easily inflammable objects, etc. Doing so could result in fire or electric shock. Homes or places with small children present should take particular care. Precautions for the PDP-425CMX/PDP-42MXE10/PDP42MXE10-S Do not connect this speaker to any amplifier other than the one supplied with this system. Connection to any other amplifier may result in malfunction or fire. Catch the hooks on the top of the speakers to the partially tightened screws, then line up the holes in the hooks on the bottom of the speakers with the screw holes on the bottom of the display and partially tighten the included screws (M8) in them. *Push the speaker against the display while driving the screw. When the speakers are installed on the display, do not move the unit by lifting up the speakers. Turn off the power of all connected units before connecting the cords. [. . . ] Otherwise the surface finish will be deteriorated or the coating will be stripped off. To remove dust from the speaker nets, use a brush adapter of a cleaner. Avoid applying the cleaner inlet directly without using a brush adapter or using a nozzle adapter. To prevent damage to the cabinet and speaker nets, do not scrach or hit them with a fingernail or other hard object. [. . . ]