User manual PIONEER PDP-S55-LR

[. . . ] Be sure to read the following descriptions carefully before reading the main text. Never place the speakers or monitor on an unsteady platform or uneven surface, as doing so might result in their falling and this in turn might result in bodily injury. Never place the speakers or monitor in a location subjected to direct sunlight or excessively high temperatures, as doing so might result in fires occurring. Never place the speakers or monitor in a location where they would be subjected to excessive levels of dust or humidity or in a location subject to steam or smoke from oil (e. [. . . ] Never raise the volume too high when using a low-output amplifier. (Doing so would result in increased distortion in the amplifier's high-frequency range , and thus result in damage to the speakers. ) Note Depending on the manner of installation, there may be times when colors blur or other effects appear on screen if the speaker is placed in close proximity to any other type of monitor. If this happens, place the speakers at a distance from the monitor during use. Make sure that all nuts, bolts, and screws are properly tightened to ensure safety. Failing to do so may result in the speakers falling, thus resulting in bodily injury. The speakers are divided into a right (R) and left (L) speaker. When attaching the speakers, be sure to check to labels (R/L) located on the rear of the speakers. 1 Remove the seals from the cushions and then attach the cushions to the sides of the speakers in the locations indicated in the diagram below. 2 Attaching the attachment pieces to the locations shown in the drawing of the Plasma Display with screws (M5) (8 locations). 7 Attachment pieces (×4) 7 Screws [M5] (×12) Check the marks on the attachment pieces (TL, TR, BL, BR) and the Plasma Display attachment locations. This product is marketed assuming that it is installed by qualified personnel with enough skill and competence. Always have an installation specialist or your dealer install and set up the product. PIONEER cannot assume liabilities for damage caused by mistake in installation or mounting, misuse, modification or a natural disaster. 3 Loosely screwing the screws (M5) into place on the top attachment pieces (2 locations). note: To install the Plasma Display on a wall, first attach the attachment pieces to the Plasma Display then install it on the wall. After installing the Plasma Display on the wall, it may be impossible to tighten the screws on the attachment pieces. ¶ Tighten the screws while pushing the speakers lightly against the Plasma Display. Check to be sure that all four screws have been screwed firmly into place. ¶ If there is a large gap between the Plasma Display and the speakers, adjust them after slightly loosening the screws that were tightened in step 2. after adjustment , re-tighten the screws. ¶ To install the Plasma Display on a wall, it is recommended that you first remove the speaker units, then after the Plasma Display has been installed on the wall, re-attach the speaker units to the Plasma Display. [. . . ] Note that the speaker cords have positive and negative ends, and that you should be sure to insert them correctly. 10 % to 90 % ¶ Specifications and design subject to possible modification without notice, due to improvements. Press the button of the speaker jack and keep it pressed down as you insert the wire of the speaker cord and then release the button. : Dimension from the front surface of the speaker to the attachment pieces. [. . . ]