User manual PIONEER PDP-S60

[. . . ] In order to prevent damage to the speaker system resulting from input overload, please observe the following precautions: · Do not use the speaker with anything other than the specified Pioneer plasma television. ⷠBe sure to turn the connected devices off and remove the power cord from the wall outlet beforehand when changing the connection or installation method. ⷠWhen using a tone control function to greatly emphasize treble sounds, do not use excessive amplifier volume. [. . . ] After passing the wide part of the hole over the screw, lower the speaker. Tighten with the provided screw the bottom speaker mounting fitting to the display temporarily (one place bottom). Connect the other end of the speaker cables to the rear of plasma television (see next page). Connect the cables correctly with respect to the polarity of the plasma television speaker terminals, that is, cable (Gray) to terminals (Red) and cable (Black) to terminals (Black). When you release the lever, it clamps onto the speaker cable. ⷠCheck if the end of the speaker cables are securely connected to the terminals by slightly tugging on the cable after making connections. Loose connections may result in sound dropouts or noise. ⷠIf there is a short in the and cables caused by an exposed lead wire, excessive load may be applied to the plasma television, resulting in interrupted operation or malfunction. ⷠIncorrect connections of the speaker cable to the right or left of the plasma television terminals with respect to the polarity may result in insufficient stereo sound effects, delivering poor bass sounds or unstable sound image. Be sure to turn the connected devices off and remove the power cord from the wall outlet beforehand when changing the connection or installation method. ⷠIf you insert the speaker cable too far so that the insulation is touching the speaker terminal, you may not get any sound. Speed clamps and bead band are included with the plasma television for tidying your cables and keeping extra cable length out of the way. Attaching speed clamps to the plasma television Attach the speed clamps using the holes marked with below, depending on your routing system. Attaching and removing speed clamps Insert [1] into an appropriate hole on the rear of the plasma television and snap [2] into the back of [1] to lock the clamp. When using the hung on wall unit: nOTE: First lay the plasma television on top of a soft sheet etc. Place the plasma television on the mounting fittings of the hung on wall unit. For details, refer to the operating instructions supplied with the hung on wall unit. Speed clamps are designed to be difficult to undo once in place. [. . . ] NOTE: Specifications and design subject to possible modification without notice, due to improvements. If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. [. . . ]