User manual PIONEER PDP-S64

[. . . ] About compatibility This product is designed exclusively for use with the Pioneer flat screen TV. For more information on compatibility, please consult with your nearest Pioneer authorized dealer or service center. about installation and setting · Do not move the flat screen TV by holding these speakers or speaker brackets. When installing the speaker, do not use any screws other than those supplied, otherwise the speaker may come off from the main unit and fall over. [. . . ] Adjust the position of the speaker and then tighten the upper and lower screws firmly. Tighten the two screws, at the top and bottom for each speaker (total of four screws), thus fixing the speakers to the flat screen TV. Hang the speaker bracket on the screw you installed at the top by passing the wide part over it and lowering into the slot; screw in the lower screw temporarily. After passing the wide part of the hole of the speaker bracket (top) over the screw, lower the speaker onto it. Pass the supplied speaker cable between the speaker and the flat screen TV (below the speaker bracket) from below. Connect the other end of the speaker cables to the rear of flat screen TV (see next page). When you release the lever, it clamps onto the speaker cable. caution · Be sure to turn the connected devices off and remove the power cord from the wall outlet beforehand when changing the connection or installation method. If you insert the speaker cable too far so that the insulation is touching the speaker terminal, you may not get any sound. Check if the end of the speaker cables are securely connected to the terminals by slightly tugging on the cable after making connections. Loose connections may result in sound dropouts or noise. If there is a short in the and cables caused by an exposed lead wire, excessive load may be applied to the flat screen TV, resulting in interrupted operation or malfunction. Incorrect connections of the speaker cable to the right or left of the flat screen TV terminals with respect to the polarity may result in insufficient stereo sound effects, delivering poor bass sounds or unstable sound image. Follow the steps below to attach a cable clamp. 1 ) Thread the clamp band through the holder and bundle the cable(s) in the cable clamp. 2 ) Push and hold the levers then insert the hook into an appropriate hole on the rear of the flat screen TV. When using the hung on wall unit: NOTE: First lay the flat screen TV on top of a soft sheet etc. Connect the other cables and power cord to the flat screen TV. [. . . ] When a chemical cloth is used, read the cautions for the chemical cloth carefully. 1 kg Accessory parts (for two speakers) . Operating Instructions × 1 NOTE: Specifications and design subject to possible modification without notice, due to improvements. Il y a un support de fixation inférieur et un support inférieure pour l'enceint gauche et pour l'enceinte droite. [. . . ]