User manual PIONEER PDP-S65

[. . . ] Please handle the speaker with sufficient care, as the grille net and the cabinet can become damaged or broken when they are subjected to strong external impacts. Placing a CRT computer screen or CRT monitor near to the speaker may result in interference or color distortion. If this happens, distance the monitor from the speaker. about the input · In order to prevent damage to the speaker system resulting from input overload, please observe the following precautions: · Do not connect this speaker to anything other than the specified flat screen TV. [. . . ] Do not move the flat screen TV holding on to the bracket. this can result in injury or damage to the flat screen TV. The screw hole at the bottom surface of the speaker bracket is used when the flat screen TV is installed on the wall. It is not used when installed with the stand. NOTE: If after attaching the speaker its position needs to be adjusted horizontally or vertically, first loosen the speaker mounting screws, reposition and then tighten the screws again at the appropriate position. When you release the lever, it clamps onto the speaker cable. caution · Be sure to turn the connected devices off and remove the power cord from the wall outlet beforehand when changing the connection or installation method. If you insert the speaker cable too far so that the insulation is touching the speaker terminal, you may not get any sound. Check if the end of the speaker cables are securely connected to the terminals by slightly tugging on the cable after making connections. Loose connections may result in sound dropouts or noise. If there is a short in the and cables caused by an exposed lead wire, excessive load may be applied to the flat screen TV, resulting in interrupted operation or malfunction. Incorrect connections of the speaker cable to the right or left of the flat screen TV terminals with respect to the polarity may result in insufficient stereo sound effects, delivering poor bass sounds or unstable sound image. Fit the cables into the groove of the speaker. Follow the steps below to attach a cable clamp. 1 ) Thread the clamp band through the holder and bundle the cable(s) in the cable clamp. 2 ) Push and hold the levers then insert the hook into an appropriate hole on the rear of the flat screen TV. NOTE: Avoid pinching or creating pressure points when routing or bundling cables. to remove the clamp band , pull and hold the latch to release. [. . . ] Tighten the three screws in order , , as shown in the diagram (see page 7). The screw hole at the rear surface of the speaker bracket is used when the flat screen TV is installed with the table top stand. It is not used when installed on the wall. NOTE: If after attaching the speaker its position needs to be adjusted horizontally, first loosen the speaker mounting screws, reposition and then tighten the screws again at the appropriate position. [. . . ]