User manual PIONEER PDP-SX4280D

[. . . ] Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. This appliance is supplied with a moulded three pin mains plug for your safety and convenience. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 13 amps and that it is approved by ASTA or BSI to BS1362. If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. [. . . ] To complete "Replace Existing Channels", there must be more than one hour at least left to the next preset recording or preset Auto Update time. The password entry screen does not appear if you have disabled the password function. You can select "DTV Setup" only when watching DTV channels. Use the following procedure to search and register new channels with the current DTV channel setups saved. If any new channel is found, it is automatically registered on the plasma television. The password entry screen does not appear if you have disabled the password function. You can select "DTV Setup" only when watching DTV channels. To quit a channel search in progress, press HOME MENU. note · The password entry screen does not appear if you have disabled the password function. You can select "DTV Setup" only when watching DTV channels. You can check the signal strength and signal quality of each TV channel. Use this function only when you wish to reset all the DTV settings to the factory defaults. Enter your four-digit password using 0 to 9. The password entry screen does not appear if you have disabled the password function. You can select "DTV Setup" only when watching DTV channels. This section describes how to customize various channel related settings. Use the following procedure to select individual channels and switch on the Favourite, Channel Skip, or Channel Lock for the channels. Use "Add New Channels" function here to add channels within the selected RF channel (receiving frequency). note · You can select "DTV Setup" only when watching DTV channels. Enter your four-digit password using buttons 0 to 9. Use the following procedure to switch on or off the power to the antenna connected with the DTV antenna terminal. Connecting any device between the aerial and plasma television may cause damage to the device. [. . . ] Check if the connections are properly made between the plasma television and the device that supports the HDMI Control functions. Check if the connections are properly made between the plasma television and the device that supports the the HDMI Control functions. Check if you have selected "Enable" in "HD AV Converter" for "HDMI Control Setting" even though no HD AV Converter is connected. Check if the connections are properly made between the plasma television and the device that supports the HDMI Control functions. [. . . ]