User manual PIONEER PDP-V402E

[. . . ] About the installation of this product: The Plasma Display is to be installed by a professional with sufficient technical skill. Please have a company specializing in equipment installation or the dealer where you bought your Plasma Display to install it. Our company is not responsible for any damage that may occur as a result of defective installation, wrong use or remodeling of your Plasma Display. this includes damage caused by natural disasters or the like. [. . . ] for installation positions , contact your nearest Pioneer authorized service station. Note that Pioneer bears no responsibility whatsoever for any problems in installation/attachment nor for any accidents or damages caused by natural disasters, etc. Use bolts which are less than 20 mm long inside the unit when fastened. Use of longer bolts will lead to damage of the internal circuit, electrical hazards, fire hazards, etc. How to Fit the Display with Cable Clamps Three cable clamps are provided to bind the connecting cables. Follow the procedure below to attach the clamps to the display. Remove the label on the rear of the display, insert the cable clamp into the two holes shown in the diagram above, and press firmly until you hear a clicking sound. When using the cable clamps provided with your display, always be sure to remove the label covering the holes into which the clamp is to be fitted before inserting the clamp into place. 2 Computer connecting cable (available on your local market) When inserting the cable, be sure to confirm the shape of the signal input terminal of the Display and that of the connecting cable connector. After inserting the cable, fix it securely by fastening the side screws. Notebook-type personal computers with a built-in LCD panel of VGA display type may have an external RGB output which is non-VGA. In this case, images are not reproduced on the main unit. , which are attached to the computer or sold separately, are needed to connect the cord to the computer. 7 In case of a Macintosh, a computer from the NEC PC-9800 series, or a machine compatible with one of these computers: Normally be sure to use set to OFF. Macintosh: You can use your Plasma Display together with the computer in the 13inch mode. This may not be applicable for some models. refer to the instruction manual for the computer used for details. 1 G on Sync mode selection switch If the images become greenish when an external device is connected to the RGB-2 input terminal, turn ON the G on SYNC mode. 2 Computer connecting cable (available on your local market) 3 A conversion adapter (available on your lacal market) Normally be sure to use set to OFF. 1 G on Sync mode selection switch If the images become greenish when an external device is connected to the RGB-2 input terminal, turn ON the G on SYNC mode. 2 Computer connecting cable (available on your local market) 3 A conversion adapter provided with the notebook-type computer. When inserting the cable, be sure to confirm the shape of the signal input terminal of the Display and that of the connecting cable connector. [. . . ] Apparatus with motors, such as a hair dryer, a vacuum cleaner, and an electric noises. You cannot operate your · the display may not properly operate under external influence , such as lightning or static electricity. In this case, turn off the POWER switch and pull the Plasma Display. Then, a few minutes later, insert the plug and turn on the POWER switch. [. . . ]