User manual PIONEER PDR-W839

[. . . ] Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory drawings. However, the method of connecting and operating the unit is the same. [. . . ] You can halt this erase process by holding down the 7 button for 10 seconds. Make sure, however, that you erase the disc completely at a later date since you can't use a partially erased disc. After a short time, the unit goes into erase standby mode: The display shows the time left to completion. ⷠYou can halt this erase process by holding down the 7 button for 10 seconds. Make sure, however, that you erase the disc completely at a later date since you can't use a partially erased disc. Although you can't erase tracks on a CD-R disc, you can set what are called `skip IDs'. These tell a CD player (though many do not recognize skip IDs) not to play a particular track, but to skip to the next one on the disc. You can also set skip IDs on CD-RWs, although it's probably a less useful feature since you can always erase the last track. Once a skip ID is set, you can clear it, but be careful: you can set up to 21 skip IDs per disc, but repeatedly setting and clearing skip IDs in different recording sessions will reduce this number. Use the 4 and ¢ buttons to select the track you want to skip. The SKIP indicator lights if the track playing is already marked with a skip ID. Use the number buttons to select tracks: · For track numbers 1 to 10, use the corresponding number button. ⷠFor track numbers over 10, press the >10 button, then enter the track number. For example, to select track 20 press >10, 2, then 10/0. ⷠYou can also use the 4 and ¢ buttons to select tracks, pressing PROGRAM after each to enter it into the playlist. After adding a track to the playlist, the display shows the disc and track number and the total playing time of the playlist: Note: the display will not show the total playing time of playlists that exceed 100 minutes. With playback stopped, delete the last (most recently) programmed track by pressing CLEAR. When the disc is stopped you can check the contents of the playlist using the CHECK button. Each press steps through the playlist, showing the step number and the corresponding disc and track number. During playback, you can add the track currently playing to the playlist by pressing PROGRAM. If there is currently no playlist, then one is created. You can program a playlist for a disc that's in the CD-R disc tray. [. . . ] After a short time, SYNC­1 or SYNC­ALL is displayed, and the recorder goes into synchro­recordpause mode. While REPAIR is displayed, the recorder automatically examines the recorded area of the disc and updates the track numbers and recording time data. This process takes about 40 minutes for a fully recorded disc. Finalization or further recording is possible once the REPAIR message disappears. [. . . ]