User manual PIONEER PRA-DW11

[. . . ] Thank you for buying this Pioneer product. Please read through these operating instructions so you will know how to operate your model properly. This product is an optional drive designed for model PRV-LX1 DVD recorder. 7 Installation of this device requires a high level of technological expertise; to assure proper operation and personal safety, installation is to be performed by a Pioneer Service representative. [. . . ] Support for this standard, however, is optional on the part of each manufacturer, with the result that depending on the DVD player or DVDROM drive involved, some may not play back such DVD-R/RW discs. Also, depending on the condition of the player's pickup and the specific combination of discs and players used, some players that support the video recording standard may not be able to play back all discs. Use only recommended disc media in order to assure stable recording and playback. Discs may become incapable of recording and playback when scratched, or when soiled with fingerprints or dust. always handle discs as noted below: ÷ Never touch the recording surface (mirror surface) when handling discs. Hold discs between their edges, or between one edge and one finger in the center hole. Do not use anti-static or other record sprays. Also, never use benzene, thinner or toher volatile cleaners to clean the surface of discs, since such chemicals may melt or otherwise damage the surface. Always store discs in their protective cases; before use, check the recording surface for fingerprints or other soiling. Do not use cracked or warped discs, since they may shatter dangerously at high rotation speeds. Do not use non-standard discs, since they may cause adverse affects to the player and other components. Condensation of moisture on the player's optical parts or disc surface is also a possibility; allow the disc and player to sit for 1-2 hours before attempting to use again. To clean fingerprints from a soiled disc, wipe gently from the center hole radially toward the circumference. Placing the jumper on a pair of pins turns the pair ON. Connect to the PRV-LX1's power cable (see installation instructions, step 9). Connectors 4, 5, and 6 are not used with the PRV-LX1. 7 When handling this unit, be very cautious never to touch any of the connectors or terminals, to prevent damage due to electrostatic discharge. Installation of this unit requires a high level of technical expertise; for this reason, and to assure safe operation, installation is to be performed by authorized Pioneer service personnel. Loose mounting screws may allow disc rotation to cause sound distortion, or the unit may fall, leading to personal injuries and physical damages to the unit or other materials. Be sure that all mounting screws are fastened securely. Use of threaded fasteners other than those designated may result in damage to the unit and DVD recorder PRV-LX1. To prevent hazard of fire, electrical shock, and potential electronic damage to the unit, be sure to detach all cables and the power cord connected to the main unit PRV-LX1 before beginning installation. [. . . ] Completion of installation 1 Press the main unit's front panel STANDBY/ON button and wait until the unit enters the standby mode. 2 Once the main unit is in the standby mode, set the unit's main power switch (on rear panel) to OFF, then disconnect the power cord from its power outlet. NOTE: Do not leave the power to the unit turned on when tray panel 2 is not installed (see step 12 for installation instructions). If tray panel 2 is not installed, dust may be pulled into the unit more easily, leading to malfunctions in recording and playback. [. . . ]