User manual PIONEER RMX-1000

[. . . ] Com/support/ The Pioneer website shown above offers FAQs, information on software and various other types of information and services to allow you to use your product in greater comfort. Operating Instructions Mode d’emploi Bedienungsanleitung Thank you for buying this Pioneer product. Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. [. . . ] 2 Move the [RELEASE FX] lever towards you. The selected effect is applied to the sound selected in the FX SOURCE section. The effect changes according to the position of the lever. When the lever is moved back to its original position, the effect turns off. Any SCENE FX, ISOLATE FX or X-PAD FX effects that were on before are also turned off. Create the customized parameter data beforehand using remixbox. Upon shipment from the factory, the same parameter data as for the [DEFAULT] mode is set for the [USER] mode. FX SOURCE section 1  Writing the customized parameter data from remixbox into this unit 1 Connect the computer on which remixbox is installed to this unit by USB cable. 2 Send the customized parameter data from remixbox to this unit. 2 3 Slide the [SETTING] selector switch to the [USER] position.  Loading customized parameter data stored on an SD memory card 1 Store the customized parameter data on the SD memory card using remixbox. 2 Insert the SD memory card used in step 1 into this unit’s SD memory card slot. 3 Slide the [SETTING] selector switch to the [USER] position. 1 INPUT button The sound input to this unit’s [INPUT] terminals is routed to this unit’s SCENE FX, ISOLATE FX and RELEASE FX sections. 2 X-PAD button The sound output from the X-PAD FX section is routed to this unit’s SCENE FX, ISOLATE FX and RELEASE FX sections. Switching the audio signal path Switch whether or not to route the sound input to this unit and the sound generated internally to this unit’s SCENE FX, ISOLATE FX and RELEASE FX sections. Customized parameter data stored on an SD memory card is reflected on this unit simply by inserting that SD memory card into this unit. The selected audio signal is input to this unit’s SCENE FX, ISOLATE FX and RELEASE FX sections. The [NOISE] effect in the SCENE FX section is applied regardless of the status of the [INPUT] and [X-PAD] buttons. 14 En English Types of effects Types of SCENE FX effects BPF ECHO This function superimposes the input sound that has passed through the band pass filter onto the original input sound and passes this through the echo circuit before outputting the sound. The echo is output several times according to the multiplying factor of the input sound’s beat, with the delay sound gradually attenuating. Input sound that has passed through the band pass filter Input sound SCENE FX control SCENE FX control SUB PARAMETER 1 control SUB PARAMETER 2 control Frequency SPIRAL UP This function adds a reverberation effect to the input sound. [. . . ] MIDI sequencers not supporting MIDI timing clocks cannot be synchronized. To operate DJ software with this unit, this unit’s MIDI messages must be assigned to the DJ software you are using. For instructions on assigning messages, see your DJ software’s operating instructions. Is the SD memory card one that is usable on this unit? [. . . ]