User manual PIONEER S-CN301-LR

[. . . ] The circuit breaker will automatically switch off and turn the speakers back on. Before you start • The nominal impedance of this speaker system is 6 Ω. Connect the speaker system to an amplifier with a load impedance ranging 6 Ω (a model with “6 Ω” displayed on the speaker output terminals). In order to prevent damage to the speaker system resulting from input overload, please observe the following precautions: • Do not supply power to the speaker system in excess of the maximum permissible input. [. . . ] € If the room has a lot of reverberation, we recommend hanging heavy fabric on the walls, and/or putting a carpet on the floor to damp the sound. For best results, cover walls completely. Screw Examples of mounting the speaker system using the safety support fixture Mounting on the wall Grille Safety support fixture Speaker’s rear view Strong cords • Do not place the speaker on an unstable surface. It could present a hazard if it falls, as well as damaging the equipment. ) from the side wall 20 cm (7 7/8 in. Placing the speakers directly on the floor will result in boomy, undefined sound. Ideally, the tweeters should be at about ear level when seated in your listening position. € This unit has two screw holes on the Use M5 screws. These holes are The screw hole depth: meant for joint use with speaker 9 mm (3/8 in. ) brackets and speaker stands; speaker brackets are commercially available and can be used to mount the speakers on a wall or ceiling. The diagram on the right shows the 60 mm (2 3/8 in. When choosing a speaker bracket, make sure that it can hold at least 2. Please read through the safety cautions on this operating instruction, also the instructions that come with the bracket. Speakers that are not mounted properly are a hazard. Mounting on the ceiling Speaker’s rear view Safety support fixture Grille Screw Strong cords Strong cords • Loosen the screw on the grille’s back once, then bind the strong cord around the screw several times and tighten the screw. € Pass two strong cords through the safety support fixture, and fasten the speaker to the wall or ceiling as shown above. € If you mount the speakers on the wall or ceiling, first make sure that the mounting surface can bear at least 2. € When installing the speaker on the ceiling, the speaker will be upside down. Even so, putting the grille in the proper way (the way you can read Pioneer logo in the right way) is recommended. € After installing, make sure the speakers are securely fixed. Book 4 ページ ２０１２年２月１０日　金曜日　午後４時３７分 • Pioneer is not responsible for any accidents or damage that result from improper installation, misuse or modification of the product, or natural disasters. Connections 1 Switch off the power of your amplifier. [. . . ] 2 Warranty card Operating instructions (this document) BE SURE TO OBSERVE THE FOLLOWING GUIDELINES: • Do not turn up the volume so high that you can’t hear what’s around you. • Use caution or temporarily discontinue use in potentially hazardous situations. € Do not use headphones while operating a motorized vehicle; the use of headphones may create a traffic hazard and is illegal in many areas. s001a_A1_En • The S-CN301-LR is shipped with two speaker systems included. [. . . ]