User manual PIONEER S-DV740

[. . . ] What's in the box Use the subwoofer stands to secure the base of the subwoofer when placing it in an upright position, or to provide support when laying it flat on its side. When the subwoofer is on its side, make sure the speaker is face-down. When using the stands to lay the subwoofer on its side, stick the supplied non-slip pads on the stands where indicated below. [. . . ] After you have finished, refer to the other side of this sheet for the speaker setup options available with this system. Attach the non-slip pads to the base of each of the center and surround speakers. Use the adhesive to attach 4 pads to the base of each speaker. After connecting the speaker wires, thread the front speaker cord through the outlet on the base of the speaker stand as shown below. Make sure to use a stable surface when doing this, and lay the speakers flat on their side. Detach the surround speakers from the front speakers. To remove, turn the surround speaker so that the arrow at its base lines up with the DETACH POSITION (%) on the top of the front speaker. Once aligned, the surround speaker can be removed easily by gently lifting it upwards. Caution To prevent accidents when in use, make sure the surround speaker is secure by turning it so the arrow at the base of the speaker is not in the UNLOCK AREA. To keep the stand steady when upright, tuck the cord into the groove on the bottom as shown below. Line up the holes with the spurs on the cover or base as shown below. This setup is ideal when rear surround speaker placement isn't possible or you want to avoid running long speaker cables in your listening area. Center Front left Subwoofer Surround left Surround right Front right After connecting the speaker wires to the surround speakers, use the groove provided to secure the speaker wire as shown at left. Leave 10cm of slack from the speaker terminals so the upper (surround) speaker can turn freely. [. . . ] Music modes (leave them facing forward with ExtraPower). Caution To prevent accidents when in use, make sure the surround speaker is secure by turning it so the arrow at the base of the speaker is not in the UNLOCK AREA. With the 3-spot setup, it is recommended that you fix the surround speakers in place with the adhesive strips provided when in use. [. . . ]