User manual PIONEER S-ESR2TB

[. . . ] €¢ In order to prevent damage to the speaker system resulting from input overload, please observe the following precautions: -Be sure to turn the connected devices off and remove the power cord from the wall outlet beforehand when changing the connection or installation method. -Do not use excessive amplifier volume if using a tone control to emphasize high or low frequencies. €¢ Do not use the speaker to output distorted sound for long periods of time. However, depending on the installation location, color distortion may occur if the speaker system is installed extremely close to the screen of a television set. [. . . ] CENTER SPEAKER • Do not attach the center speaker to the wall or ceiling. Fm 2 ページ ２０１１年２月１６日　水曜日　午後２時２９分 SURROUND SPEAKERS For best results the speakers should be positioned at or above ear level. Depending upon your room layout and preferences, the left and right rear speakers should be positioned on the side walls just the rear of the listening position, or on the walls. CONNECTING YOUR SYSTEM STANDARD SURROUND SETUP This is a standard multichannel surround sound speaker setup for optimal 5. Front left Front right Make sure all equipment is turned off before making any connections. €¢ Correct wiring of your speakers is essential for achieving the best sound quality. Be careful to ensure proper polarity of connection. cAUTION These speaker terminals carry HAZARDOUS LIVE voltage. To prevent the risk of electric shock when connecting or disconnecting the speaker cables, disconnect the power cord before touching any uninsulated parts. D3-4-2-2-3_A1_En Center Subwoofer (not supplied) Connect to the speaker terminals on the rear of the amplifier. Listening position Surround left Surround right Connect the striped speaker cord to the red (+) terminal and the other cord to the black (–) terminal as shown below (for more details, refer to your amplifier instruction manual). Amplifier Speakers NON-SKID PADS If the center and surround speakers are placed on a hard surface, such as wood or tile place four non-skid pads on the bottom flat surface of the speakers. Connect to the speaker terminals on the rear of the speakers. To connect, press the lever and insert the striped speaker cord into the red (+) terminal and the other cord into the black (–) terminal as shown below. Black Red Striped half of speaker cord Surround speakers Center speaker Other half of speaker cord MAKING AMPLIFIER SETTINGS Before connecting the speakers, please read the operating instructions supplied with your amplifier to select the speaker setting of amplifier : • CENTER / SURROUND SPEAKERS : SMALL After connecting the plugs, pull lightly on the cords to make sure that the ends of the cords are securely connected to the terminals. Poor connections can create noise and interruptions in the sound. Fm 3 ページ ２０１１年２月１６日　水曜日　午後２時２９分 WALL-MOUNTING THE SURROUND SPEAKERS Before mounting • Remember that the speaker system is heavy and that its weight could cause the screws to work loose, or the wall material to fail to support it, resulting in the speaker falling. Make sure that the wall you intend to mount the speakers on is strong enough to support them. Do not mount on plywood or soft surface walls. • Mounting screws are not supplied. [. . . ] 12 (4 pcs x 3 sheets) Operating instructions Specifications and design subject to possible modification without notice due to improvements. If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one). [. . . ]