User manual PIONEER S-FL1

[. . . ] ⷠIf you are using a stand, metal fittings, etc. With the speaker, please make sure that they are of sufficient strength to carry the load. ⷠDo not install the speaker near a heater or in direct sunlight. The sound of the speaker may be subtlely affected by the listening room conditions. [. . . ] ⷠTwo M8 diameter screw holes for mounting the speaker can be found on the top, bottom and both sides of the speaker. There are also four M6 diameter screw holes on the rear panel; please remove the caps before use. No stand or other fittings for mounting the speaker are supplied. You will need a cross-head screwdriver or hexagonal wrench for installation. 2 Use two screws with washers to attach the stand or other fitting to the speaker. Please use screws suitable for the wall material and strength. The following is a guide to the length of screws you should use for the speaker and fittings: Do not overtighten the screws as this can cause damage. ⷠTo reduce the risk of the speaker falling or toppling over should there be an accident, please reinforce the mounting fittings for added safety. 1 Use the two screw holes on the longer side of the speaker. 2 Use two screws with washers to attach the stand or other fitting to the speaker. Please take extra care in selecting a location for upright installation as the speaker is less stable. Be careful not to short the two pins (1+ and 1­) of the free speaker terminal. Doing so could damage the speaker and/or your amplifier. ⷠSwitch off the amplifier before connecting any speakers. there are two connection terminals on the rear side of the speaker. To connect the speaker to your amplifier you will need a suitable speaker cord terminated in a Neutrik Speakon® speaker connector [NL4MP]. Only the 1+ and 1­ pins should be connected. these connect to the positive (+) and negative (­) speaker terminals respectively on the amplifier. Neutrik [NL4FX] and [NL4FC] Speakon speaker cord can be used for the connection. The speaker's terminals are exactly the same; use whichever is convenient. [. . . ] The number of speakers you may connect will vary according to the impedance rating of the amplifier. See the manual that came with your amplifier for more details. ⷠThe diagram below shows the wiring of two connected speakers. Squeeze the lever on the speaker connector with your thumb, then twist the whole connector counterclockwise and pull out. [. . . ]