User manual PIONEER S-L7V-A

[. . . ] Doing so could provoke the speaker to fall, causing damages or bodily injury. With normal use, wiping with a soft cloth should be sufficient to keep the cabinet clean. If necessary, clean with a cloth dipped in a neutral cleanser diluted five or six times with water, and wrung out well. Never use alcohol, thinners, benzine, insecticide sprays or other chemicals on or near this unit since these will corrode the surfaces. [. . . ] Once decided on the location of installation (such as the wall space above or below of the TV), attach the speaker following the next procedures. Two types of brackets (for speaker) are supplied. When using alongside with a Pioneer plasma television, use the L-type bracket. When attaching flush against the wall, use the S-type bracket. Speaker cable is not included with this speaker system. This speaker does not include speaker cables used for connecting to an amplifier. Take the following factors into consideration when choosing speaker cables so that you can get the most from your speaker system: · Use heavy-gauge speaker cable if possible, and keep the cables to the minimum necessary length. Connections at speaker and amplifier terminals should be made as tight and secure as possible to help reduce contact resistance. When mounting the speaker onto wall using the bracket, connect the speaker cable before attaching speaker onto the bracket. Do not try to forcibly remove it since doing so may damage the grille. If the cables' wires happen to be pushed out of the terminals, allowing the wires to come into contact with each other, it places an excessive additional load on the amp. Pass a thick cord (not provided) around the hooks and through the metal catch so that the speaker is stabilized (make sure to test that it supports the weight of the speaker). Place the bottom left edge of the bracket (attached on the speaker) on top of the guide of the bracket (for wall) from a diagonal angle ( ). Bring right side of both brackets together so that they become horizontal to each other ( ). Move slightly to the left and slide down until stops, while aligning the left protruding section to the groove of the bracket (for wall) ( ). The following illustration does not show the speaker attached to the bracket (for speaker) for description purposes. Do not attach the metal catch directly to the wall. It should only be used in conjunction with reinforced string to prevent the speaker from falling. This speaker system can be placed on surfaces such as shelves by using the supplied speaker stand. place on surfaces by using nonskid pads or self-adhering fasteners on the speaker stand. Do not install speakers on slippery surfaces, as the strength of the non-skid pads may be insufficient to prevent the speaker system from sliding. When using the non-skid pads Paste the non-skid pads on each edge of the bottom of the speaker stand. [. . . ] Attach the speaker stand so that the speaker terminal is on the left when viewing the back of the speaker. Appearance and specifications are subject to change without notice. If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. [. . . ]