User manual PIONEER S-LX70-C

[. . . ] When using a graphic equalizer to emphasize loud sounds in the high-frequency range, do not use excessive amplifier volume. Do not try to force a low-powered amplifier to produce loud volumes of sound (the amplifier's harmonic distortion will be increased, and you may damage the speaker). Do not use the speaker to output distorted sound for long periods of time. Do not sit or stand on the speaker, or let children play on the speaker. [. . . ] This may cause the amp to stop functioning, and may even damage the amp. After connecting the plugs, pull lightly on the cables to make sure that the ends of the cables are securely connected to the terminals. Poor connections can create noise and interruptions in the sound. Be sure to connect wires to the correct terminal polarities (+ , ­) at the speaker and amplifier, or the proper surround effect will not be produced. 2 Paste the supplied wall mounting template on the area of installation. Attach the template level to the ground using an adhesive such as tape. Make sure the template is straight to avoid mounting the speaker crookedly. Pasting the template too close to the TV may cause the TV to get in the way of the speaker when installing. Make sure the template and TV do not overlap. Firmly tighten the screw [A] that was used to temporarily attach the bracket to the wall as well. To avoid speaker from wobbling or falling off, firmly attach bracket at multiple locations. The following illustration is an example of attaching the bracket with screws at five locations: Screw location [A] and the 4 corners of screw location [B] (recommended). Align the bracket (for wall) to the specified location on the template, and temporarily attach with a screw (6 mm diameter screw recommended) at location [A]. Attach the bracket on with supplied screws (long) at the 4 screw holes. this speaker system adopts a unique design that controls the directionality of the sound. Due to this feature, this speaker system must be mounted differently depending on whether it is being installed above or below the TV. attach the brackets in the direction described below. When installing above the TV When installing below the TV When installing below the TV Attach bracket so that the speaker terminal is on its left when viewing the back of the speaker. Secure the brackets together by using the supplied screws (short) at the screw holes located on the top of the left and right side of the brackets. If you cannot secure both sides (due to such cases as lack of space to use a screwdriver), make sure that one side is secured with a screw. When installing above the TV Attach bracket so that the speaker terminal is on its right when viewing the back of the speaker. Screw two picture hooks or similar into the wall behind the speaker. [. . . ] Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one). For countries not mentioned above, please contact your local authorities for the correct method of disposal. By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health. Placez le bord inférieur gauche du support (fixé sur l'enceinte) en haut du guide du support (mural) avec un angle diagonal ( ). [. . . ]