User manual PIONEER S-P310A

[. . . ] Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 10 amps and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark or the BSI mark on the body of the fuse. If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer. [. . . ] The defaults, if not stated, are listed in bold. Important · Note that if a setting doesn't appear in the AUDIO PARAMETER menu, it is unavailable due to the current source, settings and status of the receiver. 1 Press RECEIVER , then press AUDIO PARAMETER. 2 Use / to select the setting you want to adjust. Depending on the current status/mode of the receiver, certain options may not be able to be selected. Check the table below for notes on this. See the table below for the options available for each setting. 4 Press RETURN to confirm and exit the menu. Setting MCACC (MCACC preset) What it does Selects your favorite MCACC preset memory when multiple preset memories are saved. When a MCACC preset memory has been renamed, the given name is displayed. MEMORY 1 ON OFFa Switches on/off the effects of Standing Wave Control. Some monitors have a slight delay when showing video, so the soundtrack will be slightly out of sync with the picture. DELAY (Auto delay) 0dB +6 dB AMPLIFIER THROUGH OFF ON 64 En Using other functions 08 Setting What it does Option(s) 0 to 7 Default: 3 Provides a better blend of the front speakers by spreading the C. WIDTHi center channel between the front right and left speakers, making (Center Width) it sound wider (higher settings) or narrower (lower settings). (Applicable only when using a center speaker) DIMENSIONi Adjusts the depth of the surround sound balance from front to back, making the sound more distant (minus settings), or more forward (positive settings). Extends the front stereo image to include the surround speakers for a `wraparound' effect. Adjusts the center image to create a wider stereo effect with vocals. Adjust the effect from 0 (all center channel sent to front right and left speakers) to 10 (center channel sent to the center speaker only). Sets the effect level for the currently selected Advanced Surround or ALC mode (each mode can be set separately). ­3 to +3 Default: 0 OFF ON 0 to 10 Defaults: Neo:6 MUSIC: 3 Neo:6 CINEMA: 10 10 to 90 PANORAMAi C. IMAGEj (Center Image) (Applicable only when using a center speaker) EFFECT a. When EQ OFF is selected, the MCACC indicator does not light. b. This setting is only displayed when the listening mode is Stereo, Auto surround (STEREO) or ALC (STEREO). c. The adjustment can be made only when TONE is set to ON. d. With the iPod/USB input function, by default S. RTRV is set to ON. [. . . ] 0. 06 % (20 Hz to 20 kHz, 8 , 95 W/ch) Guaranteed speaker impedance . 16 to 8 , less than 8 to 6 (setting required) Signal-to-Noise Ratio (IHF, short circuited, A network) . 5 Hz to 100 000 Hz dB (Pure Direct Mode) Input (Sensitivity/Impedance). 284 mV/47 k Output (Level/Impedance) REC . [. . . ]