User manual PIONEER S-SP50-G

[. . . ] The S-SP410 system can be combined with the S-W90S to produce a 5. Read the Instruction Manual carefully before using this speaker system so that you can operate it properly. [. . . ] the rated impedance of this speaker system is 8 W. It must be connected to a amplifier which accepts this type of load (miminum and maximum impedances accepted by the amplifier are generally indicated near the loudspeaker outlets: for example "4 W to 16 W" or "6 W to 16 W"). To guard against damage to this speaker system due to an electric power overload, take the following precautions: Do not supply more than the maximum permitted power to the speaker system (see Specifications). Any connection or switching on or off of part of the audio system (CD player, tuner etc. ) must be carried out after switching off the amplifier or at least with the loudspeaker outlets disconnected (if the amplifier allows). Interference caused by these operations will otherwise reach the speaker and may damage the treble loudspeaker units. For optimum sound reproduction of high frequencies, the treble speaker units must be at the same height as the listener's ears. For low frequencies, it is possible to increase the level of bass sounds by positioning the speakers close to a wall (the maximum increase being obtained for a position in a corner of the listening room). Install the centre speaker above or below the TV so that the sound of the center channel is localized at the tv screen. Do not install these speakers close to an oven or heating appliance. These speakers are heavy and fragile, therefore it is dangerous to install them in an unstable position. REMARK : The specifications and design of this product are subject to change without notice, in the interests of improvements. [. . . ] Koppla minuskabeln till och pluskabeln till + . Koppla pluskabeln till uttaget märkt + och minuskabeln till uttaget märkt . [. . . ]