User manual PIONEER S-STP600

[. . . ] Caution · Do not connect the supplied speakers to any amplifier other than the one supplied with this system. Connection to any other smplifier may result in malfunction or fire. · Pioneer will not be responsible for any accidents or damage that may result from improper installation. [. . . ] · The surround left, right and back speakers should all be placed at about ear-level. Depending on the layout of your room, the surround left and right speakers may be mounted on the side walls, with the surround back speaker mounted on the rear wall. Red White · The surround back speaker should be placed directly behind your listening position for best performance. · Install the center speaker above or below the TV so that the sound of the center channel is localized at the TV screen. Important · Do not attach the center speaker to the wall or ceiling. If you choose to install the center speaker on top of the TV, be sure to secure it with tape or some other suitable means. Otherwise, the speaker may fall from the TV due to external shocks such as earthquakes, endangering those nearby or damaging the speaker. · Do not install speakers near a stove or other heating appliance, or put them in a place exposed to the sun. Such locations may cause the cabinet to change color and the speaker system to break down. · The front, center and surround speakers supplied with this system are magnetically shielded. However, depending on the installation location, color distortion may occur if the speaker is installed extremely close to the screen of a television set. If this happens, turn the television set off for 15 to 30 minutes before switching it back on. If the problem persists, place the speaker system away from the television set. Non-skid pads Attach the non-skid pads to the base of the speakers. Use the supplied adhesive to attach 4 pads to the base (flat surface) of each speaker. Troubleshooting Symptom No sound Possible cause · Bad speaker wire or connection · Receiver is off · Volume control is at zero · Extreme signal condition Remedy · Connect correctly or replace wire. · Turn down the amplifier's output level (volume, bass control, bass boost) to lower the level. · Turn the volume down to resume normal speaker output. Sound is distorted Speakers stop · Extreme signal producing condition for extended sound suddenly period of time Cabinet maintenance Use a polishing cloth or dry cloth to wipe off dust and dirt. If the cabinet is very dirty, clean with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and then wipe again with a dry cloth. Never use thinners, benzene, insecticide sprays and other chemicals on or near the cabinets, since these will corrode the surfaces. Caution · These speakers are equipped with a protection device to protect the transducers from extreme conditions. Under these conditions the protection device will activate and stop the speaker from producing sound. [. . . ] Closed-box bookshelf type (magnetically shielded) System. 0. 8 kg Note: Specifications and design subject to possible modification without notice due to improvements. Bracket screw (supplied) 5 mm 10 mm Mounting screw (not supplied) 5 ­ 7 mm Published by Pioneer Corporation Copyright ©2005 Pioneer Corporation All rights reserved PIONEER CORPORATION 4-1, Meguro 1-Chome, Meguro-ku, Tokyo 153-8654, Japan PIONEER ELECTRONICS (USA) INC. P. O. BOX 1540, Long Beach, California 90810-1540, U. S. A. [. . . ]