User manual PIONEER S-VSL6C

[. . . ] 1 Screws . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Washers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Self-adhering fastener (hook strip) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Self-adhering fastener (loop strip) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] When installing the speakers horizontally, use two screws installed at the two locations shown (left and right); when using a vertical installation, place one screw in the center as shown. · Using self-adhering fastener 1. Peel off the protective paper backing from the two loop strips and apply to the bottom surface of the speaker stand. Peel off the protective paper backing from the two hook strips and apply to the surface of the installation surface in alignment with the two loop strips on the speaker stand. Self-adhering fastener (loop strip) Self-adhering fastener (hook strip) Installation surface Assembly Assembling the speaker stands requires use of a medium Phillips screwdriver. Connect speaker wires before assembly Wall hanging screws (buy commercially) Installation example 1 (Horizontal installation) 1. Affix mounting pads Pads Horizontal installation Vertical installation 2. Use two supplied screws to fasten the speaker stand to the speaker 2. Loosen the screws slightly to allow the mounting fixture to be removed. Use one provided accessory screw and one washer to attach the accessory safety wire to the speaker as shown. Use two provided accessory screws to attach the speaker to the mounting fixture. Use a commercially available screw or bolt and one of the provided accessory washers to connect the loose end of the safety wire to the wall. Align the speaker with the screws installed in step 1, and fasten to the wall. 2 Installation Example 1 (Horizontal installation) Safety wire Commercially purchased screw Frequency response and harmonic distortion 100 80 45° 0° 22. 5° Accessory screws Washers 60 40 20 0 10 100 1k 10 k 50 kHz Installation Example 2 (Vertical installation) Commercially purchsed screw Safety wire Washers Specifications Accessory screws Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Fully enclosed (acoustic suspension) bookshelf speakers with magnetic-shielded design Speaker composition . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-way type Woofer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8. 3 cm cone x 2 Tweeter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 cm dome type Nominal impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 90­40, 000 Hz Output level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 86 dB / W (1 m) Permissible input Maximum power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 130 W Crossover frequency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4. 0 kHz External dimensions Speaker only Horizontal mount . . . . . . . . . . . . . . . . . . . . . . . . . . 350 (W) x 102 (H) x 80 (D) mm With speaker stand Horizontal mount . . . . . . . . . . . . . . . . . . . . . . . . 350 (W) x 126 (H) x 101 (D) mm Vertical mount . . . . . . . . . . . . . . . . . . . . . . . . . . . . 102 (W) x 385 (H) x 103 (D) mm Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] BOX 1760 LONG BEACH, CA 90801 USA Phone: 1-800-421-1404 IN CANADA CUSTOMER SERVICE DEPARTMENT PIONEER ELECTRONICS OF CANADA, INC. 300 ALLSTATE PARKWAY MARKHAM, ON L3R OP2 Phone: 905-479-4411, 1-877-283-5901 DO NOT RETURN ANY PRODUCT TO THE ABOVE ADDRESSES. THEY ARE NOT SERVICE LOCATIONS. RECORD THE PLACE AND DATE OF PURCHASE FOR FUTURE REFERENCE Model No. : _____________________ Serial No. : _______________________ Purchase Date: ___________ Purchased From: ________________________ KEEP THIS INFORMATION AND YOUR SALES RECEIPT IN A SAFE PLACE PIONEER CORPORATION 4-1, Meguro 1-Chome, Meguro-ku, Tokyo 153-8654. BOX 1540, Long Beach, California 90801-1540 PIONEER ELECTRONICS OF CANADA, INC. [. . . ]