User manual PIONEER SA-330

[. . . ] * Removing the unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . * Fastening the front panel . . . . . . . . . . . . . . . . . . . . . . 2 2 3 3 3 Installation Additional Information . . . . . . . . . . . . . . . . . . . . . . . 14 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] During the search, PI SEEK is displayed and sound is muted. Using Auto PI Seek for preset stations When preset stations cannot be recalled, the unit can be set to perform PI Seek during preset recall. · The default setting for Auto PI Seek is off. Refer to "AUTO-PI (auto PI seek)" on page 13. LOCAL (local seek tuning) Local seek tuning lets you tune in only those radio stations with sufficiently strong signals for good reception. FM: OFF ­ LEVEL 1 ­ LEVEL 2 ­ LEVEL 3 ­ LEVEL 4 MW/LW: OFF ­ LEVEL 1 ­ LEVEL 2 Larger setting number is higher level. The highest level setting allows reception of only the strongest stations, while lower settings let you receive progressively weaker stations. to confirm the selection. Receiving traffic announcements TA (traffic announcement standby) lets you receive traffic announcements automatically, regardless of the source you are listening to. Tune in a TP or enhanced other network's TP station. Press TA/AF to turn traffic announcement standby on or off. to adjust the TA volume when a traffic announcement begins. The newly set volume is stored in memory and recalled for subsequent traffic announcements. Press TA/AF while a traffic announcement is being received to cancel the announcement. to turn random play on or off. PAUSE (pause) * Press M. C. to pause or resume. Pausing playback * Press 2/PAUSE to pause or resume. S. RTRV (sound retriever) Automatically enhances compressed audio and restores rich sound. For details, refer to "Enhancing compressed audio and restoring rich sound (sound retriever)" on page 11. to confirm the selection. Note · Operation is complete even if the menu is cancelled before being confirmed. Enhancing compressed audio and restoring rich sound (sound retriever) * Press 1/S. Rtrv to cycle between: OFF (off) ­ 1 ­ 2 1 is effective for low compression rates, and 2 is effective for high compression rates. 11 ENGLISH Operating this unit Audio Adjustments 1. to change the menu option and press to select AUDIO. After selecting, perform the following procedures to set the audio function. 12 LOUDNESS (loudness) Loudness compensates for deficiencies in the low- and high-frequency ranges at low volume. OFF (off) ­ LOW(low) ­ HIGH (high) 3. to confirm the selection. ENGLISH FAD/BAL (fader/balance adjustment) You can change the fader/balance setting. Adjustment range (front/rear): F15 to R15 Adjustment range (left/right): L15 to R15 FR 0 is the proper setting when only two speakers are used. SLA (source level adjustment) SLA (Source level adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sources. · Settings are based on the FM volume level, which remains unchanged. Before adjusting source levels, compare the FM volume level with the level of the source you wish to adjust. [. . . ] 100 Hz Gain . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±12 dB Mid Frequency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 kHz Gain . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±12 dB Treble Frequency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]