User manual PIONEER SA-5500II

[. . . ] Make sure that cables will not interfere with moving parts of the vehicle, such as the gearshift, parking brake or seat sliding mechanism. If you do, the protection circuit may fail to work properly. Use of this unit in conditions other than the following could result in fire or malfunction. To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below. [. . . ] When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle's auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. Never connect the blue/white cable to the power terminal of an external power amp. Also, never connect it to the power terminal of the auto antenna. Doing so may result in battery drain or a malfunction. Ground cables for this unit and other equipment (especially, high-current products such as power amps) must be wired separately. If they are not, an accidental detachment may result in a fire or malfunction. In this case, be sure to connect 1* to 4* and 3* to 2*. ISO connector Note: In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. Consult your dealer if installation requires drilling of holes or other modifications to the vehicle. Do not install this unit where: -- it may interfere with operation of the vehicle. -- it may cause injury to a passenger as a result of a sudden stop. Do not install the display where it may (i) obstruct the driver's vision, (ii) impair the performance of any of the vehicle's operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver's ability to safely operate the vehicle. Install this unit away from hot places such as near the heater outlet. Optimum performance is obtained when the unit is installed at an angle of less than 30°. The cords must not cover up the area shown in the figure below. This is necessary to allow the amplifiers to radiate freely. Make sure you leave enough gap between the dashboard and the LCD panel of this unit so the LCD panel can be opened and closed without contacting with the dashboard. To ensure proper heat dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents when installing the unit. This unit can be properly installed using either front-mount or rear-mount installation. [. . . ] 1 Screw 2 Dashboard or console 3 Factory radio mounting bracket Note In some types of vehicles, discrepancy may occur between the unit and the dashboard. If this happens, use the supplied frame to fill the gap. 1 Determine the appropriate position where the holes on the bracket and the side of the unit match. When installing in a shallow space, use the following screw holes. [. . . ]