User manual PIONEER SA-560

[. . . ] 2 Secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place. If you do not plan to detach the front panel, the front panel can be fastened with the supplied screw. Releasing the front panel allows easier access to the trim ring. [. . . ] Use commercially available parts when installing. 2 Insert the supplied extraction keys into both sides of the unit until they click into place. # Make sure that the unit is installed securely in place. An unstable installation may cause skipping or other malfunctions. If there is enough space, use the mounting sleeve that came with the vehicle. 1 Determine the appropriate position where the holes on the bracket and the side of the unit match. In this case, be sure to connect 1* to 4* and 3* to 2*. When installing this unit in a vehicle without an ACC (accessory) position on the ignition switch, failure to connect the red cable to the terminal that detects operation of the ignition key may result in battery drain. When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle's auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. Never connect the blue/white cable to the power terminal of an external power amp. Also, never connect it to the power terminal of the auto antenna. Doing so may result in battery drain or a malfunction. Ground cables for this unit and other equipment (especially, high-current products such as power amps) must be wired separately. If they are not, an accidental detachment may result in a fire or malfunction. [. . . ] If they are not, an accidental detachment may result in a fire or malfunction. In this case, be sure to connect 1* to 4* and 3* to 2*. 12 ISO connector In some vehicles, the ISO connector may be divided into two. [. . . ]