User manual PIONEER SA-8800

[. . . ] Be sure to look behind you when reversing to confirm the view. This product features a wide-angle lens, so the near view is wide and the far view is narrow, which may create a false sense of distance. Be sure to look behind you when reversing to confirm the view. Do not wash your car with an automatic car wash or high-pressure water as it may result in water entering the camera or the camera falling off. [. . . ] Do not mount this unit near the heater outlet, where it would be affected by heat, or near the doors, where rainwater might splash onto it. Before drilling any mounting holes always check behind where you want to drill the holes. Do not drill into the gas line, brake line, electrical wiring or other important parts. If this unit is installed in the passenger compartment, anchor it securely so it does not break free while the car is moving, and cause injury or an accident. If this unit is installed under a front seat, make sure it does not obstruct seat movement. Route all leads and cords carefully around the sliding mechanism so they do not get caught or pinched in the mechanism and cause a short circuit. Locate in the position you want to install the rear view camera. Adjust the angle of the rear view camera, and install so that the camera doesn't touch the car. When sticking to a glass surface, stick it on in a position that assures the camera doesn't touch the rear window. Install so that it does not obstruct the rear field of view. Install so that it does not protrude from the side of the car. You can use Velcro tape (hard type) to attach directly to a carpet, but do not use the soft type. Install the power supply unit close enough for the rear view camera cable to reach. Support de la caméra Lorsque vous collez au centre Lorsque vous attachez la caméra en utilisant l'applique du support de la caméra (fixation avec rotation de 90°) Le support de la caméra peut être installé de différentes façons en changeant la direction dans laquelle l'applique du support de la caméra est attachée ou en attachant l'applique du support de la caméra . Attachez l'applique du support de la caméra sur le support de la caméra. Positionnez le support de la caméra de manière qu'il n'existe aucun espace entre le support et la surface de pose. Power supply unit Rear view camera connector Rear view camera Power supply unit Product with a video input jack (Hideaway unit etc. This unit is for vehicles with a 12-volt battery and negative grounding. To avoid shorts in the electrical system, be sure to disconnect the battery cable before beginning installation. Refer to the owner's manual for details on connecting the other units, then make connections correctly. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. [. . . ] If this is not done, the vehicle battery may be drained when you are away from the vehicle for several hours. 70 (W) × 23 (H) × 35 (D) mm 2-3/4 (W) × 7/8 (H) × 1-3/8 (D) in. Pull out from here Clamps Rear view camera RCA power supply cable Product with a video input jack (Hideaway unit etc. ) Power supply unit Made with a rasp etc. [. . . ]