User manual PIONEER SA-9900

[. . . ] When using the standard surround speaker setup as shown in step 3, please observe the following guidelines: · Install the main front left and right speakers at an equal distance from the TV. Install the center speaker above or below the TV so that the sound of the center channel is localized at the TV screen. * In some countries or regions, the shape of the power plug may sometimes differ from that shown in the explanatory drawings. A) then clip the loop onto the stand (fig. [. . . ] Do not mix different brands of batteries. ⷠWhen disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules that apply in your country or area. ⷠIn order to prevent battery leakage, remove the batteries when not using the remote control for an extended period (one month or more). If leakage occurs, carefully wipe away any battery fluid inside the compartment, and replace the batteries with new ones. ⷠDo not allow books or other objects to rest on top of the remote control, since the buttons may be depressed, causing faster exhaustion of the batteries. ⷠDo not use or store batteries in direct sunlight or excessively hot places, such as inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It can also reduce the life or performance of batteries. When installing the center speaker on top of the TV, be sure to secure it with tape or some other suitable means. Otherwise, the speaker may fall from the TV due to external shocks such as earthquakes, endangering those nearby or damaging the speaker. ⷠDo not connect the supplied speakers with any other amplifier. Use the supplied adhesive to attach 4 pads to the base (flat surface) of each speaker. This is a standard multichannel surround sound speaker setup for optimal 5. Attach the smaller non-skid pads to the base of each of the front speakers and the center speaker. The four large non-skid pads are for the subwoofer (as shown). Use the supplied adhesive to attach 4 pads to the base (flat surface) of each speaker. Listening position Surround left Surround right Refer to the Setting up your DVD/CD Receiver (the other part of this setup guide) to connect the speakers properly. Place them as shown in the diagram above for optimal surround sound. The base of each surround speaker fits into the circular groove on the top of the front speakers as shown. After testing for the slack necessary to turn the speaker (see the following step), use the groove provided to secure the speaker wire. Refer to the Setting up your DVD/CD Receiver (the other part of this setup guide) to connect the speakers properly. Place them as shown in the diagram above for optimal surround sound. [. . . ] ⷠPlease do not attach the brackets to the center speaker. before mounting · Remember that the speaker system is heavy and that its weight could cause the wood screws to work loose, or the wall material to fail to support it, resulting in the speaker falling. Make sure that the wall on which you intend to mount the speakers is strong enough to support them. Do not mount on plywood or soft surface walls. [. . . ]