User manual PIONEER SC-LX77-S

[. . . ] If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer. If the fitted moulded plug is unsuitable for your socket outlet, then the fuse shall be removed and the plug cut off and disposed of safely. [. . . ] If the TV and playback components support the Control with HDMI feature, the convenient Control with HDMI functions can be used (see Control with HDMI function on Operating Instructions in CD-ROM). This connection is required in order to listen to the sound of the TV over the receiver. When connecting to an HDMI/DVI-compatible monitor using the HDMI OUT 2 terminal, switch the HDMI output setting to HDMI OUT 2 or HDMI OUT ALL. For input components, connections other than HDMI connections are also possible (see Connecting your DVD player with no HDMI output on page 21). If you want to listen to the sound of the TV over the receiver, connect the receiver and TV with audio cables. Note 1 When the TV and receiver are connected by HDMI connections, if the TV supports the HDMI Audio Return Channel function, the sound of the TV is input to the receiver via the HDMI terminal, so there is no need to connect an audio cable. Connecting your DVD player with no HDMI output This diagram shows connections of a TV (with HDMI input) and DVD player (or other playback component with no HDMI output) to the receiver. If you want to listen to the sound of the TV over the receiver, connect the receiver and TV with audio cables (page 20). 1 · If you use an optical digital audio cable, you'll need to tell the receiver which digital input you connected the player to (see The Input Setup menu on Operating Instructions in CD-ROM). Note 1 When the TV and receiver are connected by HDMI connections, if the TV supports the HDMI Audio Return Channel function, the sound of the TV is input to the receiver via the HDMI terminal, so there is no need to connect an audio cable. Connecting your TV with no HDMI input This diagram shows connections of a TV (with no HDMI input) and DVD player (or other playback component) to the receiver. 2 Push open the tabs, then insert one wire fully into each terminal, then release the tabs to secure the AM antenna wires. A) then clip the loop onto the stand (fig. If you plan to mount the AM antenna to a wall or other surface, secure the stand with screws (fig. For best results, extend the FM antenna fully and fix to a wall or door frame. Don't drape loosely or leave coiled up. This receiver can power up to three independent systems in separate rooms after you have made the proper MULTIZONE connections. Different sources can be playing in three zones at the same time or, depending on your needs, the same source can also be used. The main and sub zones have independent power (the main zone power can be off while one (or both) of the sub zones is on) and the sub zones can be controlled by the remote or front panel controls. It is possible to make these connections if you have a separate TV and speakers for your primary (ZONE 2) sub zone, and a separate TV and a separate amplifier (and speakers) for your secondary (ZONE 3) sub zone. You will also need a separate amplifier if you are not using the MULTI-ZONE setup using speaker terminals (ZONE 2) below for your primary sub zone. There are two primary sub zone setups possible with this system. [. . . ] The ASBT100 model supports SCMS-T contents protection, so music can also be enjoyed on devices equipped with SCMS-T type Bluetooth wireless technology. Do not move the receiver with the Bluetooth ADAPTER connected. Doing so could cause damage or faulty contact. "Pairing" must be done before you start playback of Bluetooth wireless technology content using the Bluetooth ADAPTER. [. . . ]