User manual PIONEER SC-LX83 MANUAL 2

[. . . ] RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. This appliance is supplied with a moulded three pin mains plug for your safety and convenience. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 10 amps and that it is approved by ASTA or BSI to BS1362. [. . . ] Depending on the video component, it may not be possible to output signals connected by HDMI and other methods simultaneously, and it may be necessary to make output settings. If you want to listen to the sound of the TV over the receiver, connect the receiver and TV with audio cables (page 20). If you use an optical digital audio cable, you'll need to tell the receiver which digital input you connected the player to (see The Input Setup menu on Operating Instructions in CD-ROM). This receiver has two sets of audio/video inputs and outputs suitable for connecting analog or digital video devices, including HDD/DVD recorders and BD recorders. When you set up the receiver you'll need to tell the receiver which input you connected the recorder to (see also The Input Setup menu on Operating Instructions in CD-ROM). In order to record, you must connect the analog audio cables (the digital connection is for playback only). When doing so, also connect the receiver and TV by HDMI (see Connecting using HDMI on page 20). Connecting a satellite/cable receiver or other set-top box satellite and cable receivers , and terrestrial digital TV tuners are all examples of so-called `set-top boxes'. When you set up the receiver you'll need to tell the receiver which input you connected the set-top box to (see The Input Setup menu on Operating Instructions in CD-ROM). If your set-top box is equipped with an HDMI output terminal, we recommend connecting it to the receiver's HDMI IN terminal. When doing so, also connect the receiver and TV by HDMI (see Connecting using HDMI on page 20). For DVD Audio and SACD playback, your DVD player may have 5. 1 channel analog outputs (depending on whether your player supports surround back channels). Make sure that the player is set to output multichannel analog audio. If there is a single surround back output, connect it to the SURROUND BACK L jack on this receiver. 1-channel speaker set, use the surround speakers for the surround channel, not the surround back channel. This receiver has both digital and analog inputs, allowing you to connect audio components for playback. When you set up the receiver you'll need to tell the receiver which input you connected the component to (see also The Input Setup menu on Operating Instructions in CD-ROM). You can't hear HDMI audio through this receiver's digital out jack. turntables only: · If your turntable has a grounding wire, secure it to the ground terminal on this receiver. 1 Pull off the protective shields of both AM antenna wires. 2 Push open the tabs, then insert one wire fully into each terminal, then release the tabs to secure the AM antenna wires. [. . . ] Make sure to perform pairing the first time you operate the system or any time pairing data is cleared. The pairing step is necessary to register the Bluetooth wireless technology device to enable Bluetooth communications. 2 For more details, see also the operating instructions of your Bluetooth wireless technology device. Note 1 If this function does not operate properly, see the section on the Bluetooth ADAPTER in the CD-ROM Operating Instructions. [. . . ]