User manual PIONEER SDV-P7

[. . . ] Refer to the owner's manual for details on connecting the power amp and other units, then make connections correctly. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake, and seat rails. [. . . ] SEL cable (supplied with the display) Multi-CD player (sold separately) Speaker Unit (supplied with the display) AVX-P7000CD) (sold separately) IP-BUS cable (supplied with the display) Gray AV cable (supplied with the Multi-Channel AV Master Unit) Gray 20 pin cable (supplied with the display) Green Red 20 pin cable (supplied with the display) When Connecting the Display with RCA Input Jacks If it is installed in a location where reception of the remote control signal is not possible, use the supplied remote sensor. Instead of video output for viewing on a front display, you can connect for video output enabling viewing on a rear display (for passengers in the rear of the car). If you decide to use a rear display, be sure to follow the warnings on page 8. This product's rear video output is for connection of a display to enable passengers in the rear seats to watch the DVD or Video CD. NEVER install the display in a location that enables the Driver to watch the DVD or Video CD while Driving. This product comes with two kinds of power cord. Use the short cord when installing this product in the dashboard, and the long cord when installing it on the floor. This lead must be connected to the power supply side of the parking brake switch. Yellow To terminal always supplied with power regardless of ignition switch position. Before finally installing the unit, connect the wiring temporarily, making sure it is all connected up properly, and the unit and the system work properly. Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. The semiconductor laser will be damaged if it overheats, so don't install the unit anywhere hot -- for instance, near a heater outlet. If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance. When mounting this unit, make sure none of the leads are trapped between this unit and the surrounding metalwork or fittings. Do not mount this unit near the heater outlet, where it would be affected by heat, or near the doors, where rainwater might splash onto it. [. . . ] Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out. Do not install on the dashboard where it may be subjected to direct sunlight. [. . . ]