User manual PIONEER SPEC-2 service manual

[. . . ] However the method of connecting and operating the unit is the same. RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. If the AC plug of this unit does not match the AC outlet you want to use, the plug must be removed and appropriate one fitted. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. [. . . ] When HEADPHONES CUE (MASTER) button is selected, the master audio is output from the R channel. sTEREO: The audio source selected with the HEADPHONES CUE button is output in stereo. 29 Headphones mixing dial (MIXING) When rotated clockwise (toward [MASTER]), the master output audio is produced at the headphones (only when [MASTER] has been selected with the HEADPHONES CUE button); when rotated counterclockwise (toward [CUE]), the headphones output becomes the mixture of the effect monitor and the channel selected with the HEADPHONES CUE button. In the middle position, the audio from [MASTER] and [CUE] will be output. 30 Headphones level adjust dial (LEVEL) Adjusts the output level of the headphones jack. Some effects can be set for "3/4". With some effects, these are used for functions other than setting the beat. 33 MIDI ON/OFF button Sets MIDI output function (not including timing lock) to ON/OFF. When power is first turned ON, automatically defaults to OFF. When this control is enabled, the [MIDI START (STOP)] message appears for two seconds on the display. 36 TAP button The BPM is calculated from the intervals at which the TAP button is struck. Use the MIC 1 LEVEL dial to adjust the sound volume of MIC 1, and use the MIC 2 LEVEL dial to adjust the sound volume of MIC 2. Use the channel fader lever to adjust the sound volume of the selected channel. To use the cross fader on the selected channel, set the CROSS FADER ASSIGN switch to either cross fader channel A or channel B, and operate the cross fader lever. When not using the cross fader, set the CROSS FADER ASSIGN switch to [THRU]. Use the MASTER LEVEL dial to adjust the overall sound volume. Use the BALANCE dial to adjust the sound balance between right and left. Use the BOOTH MONITOR LEVEL dial to adjust the sound volume. The BOOTH MONITOR LEVEL dial can be used to adjust the sound volume independently of the MASTER LEVEL dial. When HEADPHONES CUE (MASTER) button is selected, the master audio is output from the R channel. When set to the [STEREO] position, the sound corresponding to the selected HEADPHONES CUE button is output in stereo. When [MONO SPLIT] is selected, use the MIXING dial to adjust the balance of sound between the left channel (sound selected with the HEADPHONES CUE button), and the right channel (the master sound ­ but only when the HEADPHONES CUE button for the [MASTER] is ON). [. . . ] Once the SPEC-2-S/SPEC-2-K is setup with parameters for a given purpose, that set of parameters can be recorded as a snapshot. When snapshot of the current status is recorded, all messages for control change and program change are transmitted. Use the MIDI ON/OFF button to control whether the MIDI control signal is generated. Even when MIDI OFF is selected, however, timing clock and snap shot functions are supported. [. . . ]