User manual PIONEER SX-20-S

[. . . ] Use in other areas may result in poor reception. The RDS (radio data system) function only operates in areas with broadcasting RDS signals for FM stations. Head unit 1 2 34 5 6 1 Indicator (list) Sub information section TA (traffic announcements) TP (traffic program identification) (sound retriever) LOC (repeat) (random) State The list function is being operated. 2 7 8 CAUTION This product is a class 1 laser product classified under the Safety of laser products, IEC 60825-1:2007. [. . . ] CUSTOM2 is a shared setting used in common for all sources. To cycle between the following: Equalizer band—Equalizer level 5 Turn M. You can also switch the equalizer by pressing repeatedly. LOUDNESS (loudness) Loudness compensates for deficiencies in the lowfrequency and high-frequency ranges at low volume. W (subwoofer on/off setting) This unit is equipped with a subwoofer output which can be turned on or off. W CTRL (subwoofer adjustment) Only frequencies lower than those in the selected range are outputted from the subwoofer. To cycle between the following: Cut-off frequency—Output level—Slope level Rates that can be adjusted will flash. HPF SETTING (high pass filter adjustment) When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are output from the front or rear speakers. To cycle between the following: Cut-off frequency—Slope level 3 Turn M. Cut-off frequency: OFF—50HZ—63HZ—80HZ —100HZ—125HZ—160HZ—200HZ Slope level: –6— –12 SLA (source level adjustment) SLA (Source level adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sources. € Secure the wiring with cable clamps or adhesive tape. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring. € Place all cables away from moving parts, such as the shift lever and seat rails. € Place all cables away from hot places, such as near the heater outlet. € Do not connect the yellow cable to the battery by passing it through the hole to the engine compartment. € Cover any disconnected cable connectors with insulating tape. € Never cut the insulation of the power cable of this unit in order to share the power with other devices. The current capacity of the cable is limited. When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle’s auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. [. . . ] Read the precautions for discs before using them. DualDiscs DualDiscs are two-sided discs that have a recordable CD for audio on one side and a recordable DVD for video on the other. Since the CD side of DualDiscs is not physically compatible with the general CD standard, it may not be possible to play the CD side with this unit. Frequent loading and ejecting of a DualDisc may result in scratches on the disc. [. . . ]